Cisco Firepower 2140 Kurulum ve Bakım

Sunucu Cisco Firepower 2140 için çevrimiçi göz atın veya pdf Kurulum ve Bakım indirin. Cisco Firepower 2140 26 sayfaları. Rack-mount and ground the chassis
Ayrıca Cisco Firepower 2140 için: Manuel (12 sayfalar), Dağıtım Kılavuzu (8 sayfalar), Başlarken (42 sayfalar)

Sayfayı Yazdır

Installation, Maintenance, and Upgrade

•

Install, Remove, and Replace the Network Module

You can remove and replace the network module in the Firepower 2130 and 2140. Although the hardware

supports removing and replacing the network module while the system is running, the software does not

currently support hot swapping. You must power down the chassis to remove and replace network modules.

See

Network Modules

This procedure describes how to install a network module into an empty slot that has never contained a network

module, and how to remove an installed network module and replace it with another network module.

Safety Warnings

Warning

Install, Remove, and Replace the Network Module, on page 1

Remove and Replace the SSD, on page 3

Remove and Replace the Power Supply Module, on page 6

Connect the DC Power Supply Module, on page 9

Secure the Power Cord on the Power Supply Module, on page 14

Remove and Replace the Fan Tray, on page 18

Install the FIPS Opacity Shield in a Two-Post Rack, on page 20

Install the FIPS Opacity Shield in a Four-Post Rack, on page 23

for more information.

Take note of the following component replacement safety warnings:

Statement 1028 More Than One Power Supply

This unit might have more than one power supply connection. To reduce risk of electric shock, remove

all connections to de-energize the unit.

Installation, Maintenance, and Upgrade