Cisco Nexus 7000 Series Sorun Giderme Kılavuzu - Sayfa 10

Sunucu Cisco Nexus 7000 Series için çevrimiçi göz atın veya pdf Sorun Giderme Kılavuzu indirin. Cisco Nexus 7000 Series 10 sayfaları. Switch chassis
Ayrıca Cisco Nexus 7000 Series için: Referans Kılavuzu (2 sayfalar), Kurulum Talimatları Kılavuzu (39 sayfalar), Referans (34 sayfalar), Kurulum Kılavuzu (18 sayfalar), Yapılandırma (8 sayfalar), Yapılandırma Kılavuzu (28 sayfalar), Hızlı Başlangıç Kılavuzu (10 sayfalar), Hızlı Başlangıç Kılavuzu (29 sayfalar), Değiştirme Talimatları Kılavuzu (14 sayfalar), Değiştirme Talimatları Kılavuzu (21 sayfalar), Kurulum Kılavuzu (16 sayfalar)

Contacting Customer Service

d) Place one hand on the module handle and pull the module part way out of the chassis.

e) Push the module back into the chassis until it is seated on the midplane.

f) Simultaneously rotate both ejector levers to the front of the module to fully seat the module.

g) Make sure that each of the captive screws on the module is aligned with its holes in the chassis.

h) Securely tighten each captive screw (to 8 in-lb [0.9 N·m]) to the chassis.

Step 4

Contact TAC for assistance (see the

Contacting Customer Service

If you cannot solve a startup problem after using the troubleshooting suggestions in this chapter, contact the

Technical Assistance Center (TAC) for assistance and additional instructions. Provide the following information

to help your TAC representative address your problem as quickly as possible:

• Date that you received the switch

• Chassis serial number (located on a label on the right of the rear panel of the chassis)

• Type of software and release number

• Maintenance agreement or warranty information

• Brief description of the problem

• Brief explanation of the steps that you have already taken to isolate and resolve the problem

Note

To contact TAC, go to

Troubleshooting

Contacting Customer Service, on page

If you have CLI access, enter the show sprom all command to display the backplane contents.

http://tools.cisco.com/ServiceRequestTool/create/launch.do .

10).

Troubleshooting