Cisco UCS B260 M4 Kurulum ve Servis Notu - Sayfa 17
Sunucu Cisco UCS B260 M4 için çevrimiçi göz atın veya pdf Kurulum ve Servis Notu indirin. Cisco UCS B260 M4 46 sayfaları. Blade server
Ayrıca Cisco UCS B260 M4 için: Kurulum ve Servis Notu (50 sayfalar)
Sayfayı Yazdır
Installing a Blade Server
This chapter contains the following sections:
•
•
•
•
•
Installing a Blade Server in the Chassis
If a UCS B460 M4 blade server is mixed with other full-width or half-width blades in the chassis, the UCS
B460 M4 blade servers must occupy the bottom two full-width slots in the chassis. The chassis should be
loaded with the largest server on the bottom, starting with a UCS B460 M4 blade server on the bottom,
followed by full-width blades above, and the half-width blades at the very top of the chassis.
Procedure
Step 1
If necessary, remove the slot divider from the chassis.
a) Simultaneously pull up on the left side catch and push down on the right side catch as shown in callout 1
of the following figure.
Installing a Blade Server in the Chassis, page 9
Server Configuration, page 11
Powering Off a Blade Server, page 12
Removing a Blade Server from the Chassis, page 12
Server Troubleshooting, page 13
Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs
2
C H A P T E R
9