Cisco UCS B420 M3 Yükseltme Kılavuzu - Sayfa 3

Sunucu Cisco UCS B420 M3 için çevrimiçi göz atın veya pdf Yükseltme Kılavuzu indirin. Cisco UCS B420 M3 8 sayfaları. High performance blade server
Ayrıca Cisco UCS B420 M3 için: Kurulum ve Servis Notu (38 sayfalar)

Sayfayı Yazdır

Upgrade Scenario 1: UCSM and BIOS Earlier Than Version 2.2(2c), CPU Earlier Than Intel E5-4600 v2

This scenario assumes the following conditions:

•

In this case, use the following procedure to upgrade the server and CPUs.

Upgrade the Cisco UCS Manager software to version 2.2(2c) or later. The required server CIMC and

Step 1

BIOS are also included with the 2.2(2c) download bundle.

Use the procedures in the appropriate upgrade guide for Release 2.1 (depending on your current software

version):

Use Cisco UCS Manager 2.2(2c) to upgrade and activate the server CIMC to version 2.2(2c) or later.

Step 2

Use the GUI or CLI procedures in the

Use Cisco UCS Manager 2.2(2c) to upgrade and activate the server BIOS to version 2.2(2c) or later.

Step 3

Use the GUI or CLI procedures in the

Disassociate the server in Cisco UCS Manager.

Step 4

Step 5

Power off the server.

Step 6

Replace the CPUs with the Intel E5-4600 v2 Series CPUs.

Use the procedures in the

Reinsert the server to the chassis.

Step 7

Wait for Cisco UCS Manager to automatically discover the server.

Step 8

Note

Clear the WILL_BOOT_FAULT

Step 9

Upgrade Scenario 2: UCSM and BIOS at Version 2.2(2c) or Later, CPU Earlier Than Intel E5-4600 v2

This scenario assumes the following conditions:

•

OL-28629-01

The Cisco UCS Manager software is at a version earlier than 2.2(2c).

The server is at a BIOS/CIMC version earlier than 2.2(2c).

The server is using CPUs earlier than Intel E5-4600 v2 Series.

UCS Manager Install and Upgrade

Blade Server Installation and Service Note

At this point, the Health LED of the server shows a critical fault and Cisco UCS Manager reports

a generic error message:

controller activation is required, as described in the next step.

In the Navigation pane, click the Equipment tab.

On the Equipment tab, expand Equipment > Chassis > Chassis number > Servers, then choose

your server.

In the Work pane, click the General tab.

In the Actions area, click Recover Server.

In the Recover Server dialog, click Reset CIMC (Server Controller), then click OK.

Wait for CIMC to reboot and for Cisco UCS Manager to do a shallow discovery of the server. This

takes two to three minutes. At the end of this process the WILL_BOOT_FAULT is cleared.

The Cisco UCS Manager software is at version 2.2(2c) or later.

Guides.

UCS Manager Install and Upgrade Guides.

WILL_BOOT_FAULT: Sensor failure asserted

using the Cisco UCS Manager GUI to reset the server CIMC:

Cisco UCS B420 M3 Server Upgrade Guide for Intel E5-4600 v2 Series CPUs

Cisco UCS Blade Server

for your server.

. This is because a board