Cisco ASR 5000 Kurulum Kılavuzu

Ağ Geçidi Cisco ASR 5000 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco ASR 5000 18 sayfaları. Applying power and verifying the installation
Ayrıca Cisco ASR 5000 için: Kurulum Kılavuzu (33 sayfalar), Kurulum Prosedürü (8 sayfalar), Kurulum Kılavuzu (37 sayfalar)

Sayfayı Yazdır

Chassis Installation

This chapter provides information on rack configurations and instructions for installing and removing the

chassis and its sub-components – the upper and lower fan trays and the Power Filter Units (PFUs).

Important

This chapter includes the following sections:

•

Equipment Rack Configuration

The chassis is designed for installation in a standard 19-inch (48.26 cm) equipment rack. Additional rack

hardware, such as extension brackets, may be used to install the chassis in a standard 23-inch (58.42 cm) rack.

Each chassis is 24.50 inches (62.23 cm) high. This equates to roughly 14 Rack Mount Units (RMUs: 1 RMU

= 1.75 in (4.45 cm).

You can mount a maximum of three chassis in a standard 48 RMU (7 ft.) equipment rack or telco cabinet

provided that all system cooling and ventilation requirements are met. A fully-loaded rack with three chassis

installed has approximately 5.5 inches (13.97 cm, 3.14 RMUs) of vertical space remaining.

When planning chassis installation, take care to ensure that the equipment rack or cabinet hardware does

Caution

not hinder air flow at any of the intake or exhaust vents. Additionally, ensure that the environmental control

system (HVAC) allows the system to function within the required limits.

Prior to installation, personnel should review and be familiar with all recommendations for Central Office

installations, as found in Telcordia GR-1275-CORE Central Office Environment Installation/Removal

Generic Requirements, Issue 3, December 2001.

Equipment Rack Configuration, page 1

Weight Considerations, page 3

Unpacking the ASR 5000 Chassis, page 3

Installing the Chassis, page 6

ASR 5000 Installation Guide