Cisco IOS Router Başlangıç Kılavuzu - Sayfa 10
Ağ Geçidi Cisco IOS Router için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco IOS Router 12 sayfaları. Siemens hipath 4000 release 1 and siemens hicom 330e release 3.1 to cisco ios voice gateway using e1 qsig with h.323
Ayrıca Cisco IOS Router için: Ürün Bilgileri (11 sayfalar), Uygulama Notu (41 sayfalar)
Sayfayı Yazdır
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Here is another example to enable all signatures belonging to signature Cisco IOS IPS basic
category.
training#configure terminal
Enter configuration commands, one per line.
training(config)#ip ips signature-category
training(config-ips-category)# category ios_ips basic
training(config-ips-category-action)#enabled true
training(config-ips-category-action)#exit
training(config-ips-category)#exit
Do you want to accept these changes? [confirm]y
Additional Commands and References
Cisco IOS IPS Configuration Guide:
http://www.cisco.com/en/US/products/ps6441/products_feature_guide09186a0080747eb0.html
7 Retire/Unretire Signatures
You can use the Cisco IOS Software CLI to retire or unretire one signature or a group of
signatures based on signature categories.
Retiring a signature means Cisco IOS IPS will not compile that signature into memory for
scanning. Unretiring a signature instructs Cisco IOS IPS to compile the signature into memory and
use the signature to scan traffic.
Following are sample CLI commands to retire signature 6130/10.
training#configure terminal
Enter configuration commands, one per line.
training(config)#ip ips signature-definition
training(config-sigdef)#signature 6130 10
training(config-sigdef-sig)#status
training(config-sigdef-sig-status)#retired true
training(config-sigdef-sig-status)#exit
training(config-sigdef-sig)#exit
training(config-sigdef)#exit
Do you want to accept these changes? [confirm]y
training(config)#
White Paper
End with CNTL/Z
End with CNTL/Z.
Page 10 of 12