Epson Stylus Photo RX700 Series Ürün Bilgileri - Sayfa 8
Tarayıcı Epson Stylus Photo RX700 Series için çevrimiçi göz atın veya pdf Ürün Bilgileri indirin. Epson Stylus Photo RX700 Series 17 sayfaları. Epson scan icm updater v1.20 (psb.2008.07.001)
Ayrıca Epson Stylus Photo RX700 Series için: Buradan Başlayın Kılavuzu (8 sayfalar), Güncelleme (1 sayfalar), Buradan başlayın (2 sayfalar)
Sayfayı Yazdır
Epson Stylus Photo RX700
Making Prints from Slides or
Negatives
You can use the film holder that came with the Epson Stylus
Photo RX700 to scan 35-mm slides or strips of negative and
positive film.
Removing the Document Mat and Film
Holder
1. Open the scanner lid and remove the document mat.
2. If you've stored the film holder in the scanner lid, remove it
as shown.
3. Place your film in the holder as described in the following
sections.
Epson Stylus Photo RX700
8 -
Placing 35-mm Slides in the Holder
1. Fit the holder's tabs into the two small holes at the rear edge
of the glass. Make sure the cutouts for 35-mm slides are in
the middle of the glass (not at the rear edge) to align them
with the fluorescent lamp when you close the lid.
Cutouts for slides
are in middle of glass
2. Place your slides in the film holder as shown.
Note:
The photos should be mirror-imaged when viewed from
overhead. (The shinier side of the film faces down; the duller side
faces up.)
To avoid cropping of your photos, always place your slides with
the wider part of the film width-wise on the glass (in landscape
orientation).
Continue with the steps on page 9 to scan and print your
photos.
5/05
Fluorescent lamp