Epson Stylus Photo RX700 Series Ürün Bilgileri - Sayfa 9
Tarayıcı Epson Stylus Photo RX700 Series için çevrimiçi göz atın veya pdf Ürün Bilgileri indirin. Epson Stylus Photo RX700 Series 17 sayfaları. Epson scan icm updater v1.20 (psb.2008.07.001)
Ayrıca Epson Stylus Photo RX700 Series için: Buradan Başlayın Kılavuzu (8 sayfalar), Güncelleme (1 sayfalar), Buradan başlayın (2 sayfalar)
Sayfayı Yazdır
Placing 35-mm Film Strips in the Holder
1. Remove the film strip cover.
2. Slide your film strip into the holder.
Note:
The photos should be mirror-imaged when viewed from
overhead. (The shinier side of the film faces down; the duller side
faces up.)
3. Replace the film strip cover.
4. Fit the holder's tabs into the two small holes at the rear edge
of the glass. Make sure the film strip is in the middle of the
glass (not at the rear edge) to align it with the fluorescent
lamp when you close the lid.
Film strip is in
middle of glass
Continue with the steps in the next section to scan and print
your photos.
Fluorescent lamp
Scanning and Printing Your Photos
1. Close the scanner lid.
2. Press the
Slides Negatives
below.
Note:
Do not press the Copy button, or the film holder will be scanned
instead of the film.
3. Select
Custom Print
4. Select
Photo(Single)
5. On the next screen, use the u, d, l, r arrow buttons to
select basic print settings. Press
settings.
❏
: Select the setting for the type of paper
Paper Type
you've loaded (see page 7).
❏
: Select the size of paper you've loaded.
Paper Size
❏
: If you want to print without white borders
Layout
around the edges, choose
choose
with Border
❏
: Turn on to restore color to faded slides or
Restoration
negatives (see page 10).
5/05
Epson Stylus Photo RX700
button. You see the screen
, then press
. You see this screen:
OK
, then press
.
OK
when done making your
OK
. Otherwise
Borderless
.
Epson Stylus Photo RX700
- 9