Crow EDS-2000AM Kurulum Talimatları Kılavuzu - Sayfa 12
Aksesuarlar Crow EDS-2000AM için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Crow EDS-2000AM 18 sayfaları. Outdoor pir + mw detector
Ayrıca Crow EDS-2000AM için: Kurulum Talimatları Kılavuzu (18 sayfalar), Kurulum Talimatları ve Kullanım Kılavuzu (20 sayfalar)
Sayfayı Yazdır
General configuration setting table (for SW2)
Feature
Indication LEDs
Anti Mask
PIR pulse count
Pet immunity
Factory setting is marked with (*) and match the EN50131-2-4 compliance test setups.
The sensitivity adjustment is performed by setting a potentiometer and MW jumper as
Follows (using clock needle positioning):
Environment type
Maximum sensitivity
Middle sensitivity
M inimum sensitivity
Note: Adjust sensitivity according to environmental conditions!
8.2.2 MW Sensitivity adjustment
The MW has 4 configurable levels by SW1:
Position 1
Position 2
UP
UP
DOWN
DOWN
DOWN
DOWN
Note: Setting both MW switches to UP position sets PIR sensitivity to Pulse 1, disregarding the PIR
switche status (SW2, position 3). This way very high sensitivity is achieved.
Factory setting is marked with (*) and match the EN50131-2-4 compliance test setups.
SW position
1
2
3
4
Potentiometer position
4 o'clock
12 o'clock
8 o'clock
UP
(*) High sensitivity more suitable for indoor application
High sensitivity for outdoor application
UP
Medium sensitivity for outdoor application
Low sensitivity for outdoor application
On (up)
Indication LEDs on (*)
ON (*)
2 pulses(*)
On
12
Off (down)
Indication LEDs off
Off
3 pulses
Off (*)