Crow EDS-2000AM Інструкція з монтажу Посібник з монтажу - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Аксесуари Crow EDS-2000AM. Crow EDS-2000AM 18 сторінок. Outdoor pir + mw detector
Також для Crow EDS-2000AM: Інструкція з монтажу Посібник з монтажу (18 сторінок), Інструкція з монтажу та посібник користувача (20 сторінок)

General configuration setting table (for SW2)

Feature

Indication LEDs

Anti Mask

PIR pulse count

Pet immunity

Factory setting is marked with (*) and match the EN50131-2-4 compliance test setups.

The sensitivity adjustment is performed by setting a potentiometer and MW jumper as

Follows (using clock needle positioning):

Environment type

Maximum sensitivity

Middle sensitivity

M inimum sensitivity

Note: Adjust sensitivity according to environmental conditions!

8.2.2 MW Sensitivity adjustment

The MW has 4 configurable levels by SW1:

Position 1

Position 2

DOWN

Note: Setting both MW switches to UP position sets PIR sensitivity to Pulse 1, disregarding the PIR

switche status (SW2, position 3). This way very high sensitivity is achieved.

Factory setting is marked with (*) and match the EN50131-2-4 compliance test setups.

SW position

Potentiometer position

4 o'clock

12 o'clock

8 o'clock

(*) High sensitivity more suitable for indoor application

High sensitivity for outdoor application

Medium sensitivity for outdoor application

Low sensitivity for outdoor application

On (up)

Indication LEDs on (*)

ON (*)

2 pulses(*)

Off (down)

Indication LEDs off

Off

3 pulses

Off (*)