Motorola ASTRO Digital XTS 3000 Temel Servis Kılavuzu - Sayfa 33

Radyo Motorola ASTRO Digital XTS 3000 için çevrimiçi göz atın veya pdf Temel Servis Kılavuzu indirin. Motorola ASTRO Digital XTS 3000 48 sayfaları. Handheld radio
Ayrıca Motorola ASTRO Digital XTS 3000 için: Operatör El Kitabı (12 sayfalar)

Sayfayı Yazdır

Motorola ASTRO Digital XTS 3000 Temel Servis Kılavuzu

Universal

Connector

Cover

Installing the

Universal

Connector Cover

Removing the

Universal

Connector Cover

Frequency

Knob

Removing the

Frequency Knob

Installing the

Frequency Knob

When the universal connector is not in use, keep it covered

with the universal connector cover.

C a u t i o n

1. Looking at the antenna side of the radio,

insert the top (ﬂat) hooked end of the cover

into the slot on the top of the radio, above

the universal connector. Press downward on

the cover's top to seat it in the slot.

2. While holding the cover seated in the top

slot, insert the cover's bottom (rounded)

hooked end into the slot below the universal

connector. Press ﬁrmly inward on the cover's

bottom until it snaps in place.

1. Looking at the antenna side of the radio,

insert a ﬂat-bladed screwdriver into the area

between the lower end of the universal

connector cover and the slot below the

universal connector.

2. Pry upward on the cover's lower end until it

disengages from the radio.

NOTES:

•

Refer to Figure 8, the Partial Exploded View, and Table 12, the

Partial Exploded View Parts List. Numbers in parentheses ( ) refer to

item numbers in Figure 8 and Table 12.

•

The battery (7) should be removed from the radio before installing

or removing the frequency knob (1).

1. Hold the radio in one hand so that the top of the radio faces upward, and

the front of the radio faces you.

2. With the other hand, grasp the frequency knob (1) and pull it upward,

while pushing it toward the back of the radio, until it is free from the

frequency insert (3).

3. While pressing the insert's (3) two snap tabs away from the frequency

control shaft so that the insert disengages from the shaft, use needle-nosed

pliers to lift the insert up and off of the frequency control shaft.

4. Remove the secure lever (4) and the lightpipe (5).

1. Hold the radio so that the top of the radio faces upward, and the front of

the radio faces you.

Top

Slot

Hooked End

Bottom

Hooked End

Bottom

Slot