Motorola XiR Series Hızlı Referans Kartı - Sayfa 4
Radyo Motorola XiR Series için çevrimiçi göz atın veya pdf Hızlı Referans Kartı indirin. Motorola XiR Series 8 sayfaları. Digital mobile radios
Ayrıca Motorola XiR Series için: Hızlı Referans Kartı (2 sayfalar)
Sayfayı Yazdır
3
Wait for the Talk Permit Tone to finish (if
enabled) and speak clearly into the
microphone.
During a Site All Call, you will not be able to use
any programmed button functions until the call
ends.
Making a Phone Call
Procedure:
1
Press the Phone Manual Dial programmable
button, and then go to Step 6.
OR
S
Press
and follow the following steps.
2
P
Q
or
(if necessary) to
N.
press
3
P
Q
or
to Manual Dial and press
4
P
Q
or
(if necessary) to Phone Number
N.
and press
5
The first line of the display shows Phone
Number: The second line of the display
shows a cursor. Use the keypad to enter a
telephone number and press
6
The first line of the display shows Calling.
The second line of the display shows the
dialed number and the Phone Call icon.
7
If successful:
You will hear audio from the phone line
(ringing, busy tone, etc.). The display shows
Phone Call.
English
OR
If unsuccessful:
A tone sounds and the display shows Phone
Call Failed (or other message).
8
Hold the radio vertically 1 to 2 inches (2.5 to
5.0 cm) from your mouth.
9
Press the PTT button to talk and release it to
listen.
10
To enter extra digits, if requested by the
Phone Call:
Buffer Dial Method: Press any keypad key
(0-9,*,#) to begin the input of extra digits. The
first line of the display shows Extra Digits:
The second line of the display shows a
cursor. Enter the extra digits and press
Contacts
and
proceed.
OR
N.
Live Dial Method: Press and hold PTT, and
then press and release each extra digit. The
radio sends a DTMF tone for each extra digit.
Release PTT when finished.
11
The Phone Call can be ended by the phone
user or the radio user.
N
R
to proceed.
12
Press
13
When the call is over, the display shows
Phone Call Ended.
Scanning Talkgroups
If your radio has been programmed with a Scan
button, use the button to toggle the feature on or
off. If your radio has been programmed so that
N
to
to end the call.
Scan can be turned on or off via the menu, the
procedure is as follows:
1
S
to access the menu.
2
P
Q
or
to Scan option and press
select.
3
You see Scan On or Scan Off, depending on
the previous selection. Press
During scan, the green and yellow LEDs blink,
and the Scan icon is displayed.
Making a Call Alert
Press the programmed One Touch Call button
and proceed to Step 5.
OR
Follow the procedure below.
1
S
to access the menu.
2
P
Q
or
to Contacts. Press
3
P
Q
or
to the required subscriber alias or
N
ID and press
to select.
4
P
Q
or
to Call Alert and press
select.
5
The display shows Call Alert:
<Subscriber Alias or ID>.
6
If the Call Alert acknowledgement is received,
a tone sounds and the display shows Call
Alert Successful.
OR
If the Call Alert acknowledgement is not
N
to
N
to select.
N
to select.
N
to