Epson TM-L90 series Kullanıcı Kılavuzu - Sayfa 14

Etiket makinesi Epson TM-L90 series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Epson TM-L90 series 17 sayfaları. Attaching cover on the power switch
Ayrıca Epson TM-L90 series için: Broşür (1 sayfalar), Broşür (2 sayfalar), Teknik Özellikler (2 sayfalar), Teknik Özellikler (8 sayfalar), Bilgi Kılavuzu (5 sayfalar), Teknik Özellikler (4 sayfalar), Buradan başlayın (2 sayfalar), Buradan başlayın (2 sayfalar), Manuel (13 sayfalar), Talimatlar Kılavuzu (12 sayfalar), Manuel (2 sayfalar)

English

Using Different Paper Widths

Be sure to set the paper width with the memory switch to match printing to the

print width. (For detailed information on the memory switch, see the TM-L90 with

Peeler Technical Reference Guide.)

Also, do not increase the paper width after you have used a narrower width. For

example, do not use 60 mm {2.36"} and then change to 80 mm {3.15"}.

The reason not to increase the width setting if the printer has ever been used is

that when narrow paper is used, part of the head contacts the platen. Therefore,

when a wider setting is used, part of the head or the cutter blade may be worn out,

which can cause poor printing.

The TM-L90 accommodates 80 mm wide roll paper with no adjustments. For rolls

from 38 mm to 70 mm wide you use the spacer included with the printer. (Rolls

from 71 mm to 79 mm cannot be specified.) If the rolls are from 61 to 70 mm wide,

you break two tabs off the spacer. See the width note on page 11.

Insert the roll paper spacer so that the front edge goes through the notch and

down to the shaft, as shown below.

front edge

Push the roll paper spacer until you feel it click onto the shaft.

Note:

Check that the roll paper spacer slides smoothly to the left and right.

shaft

10 TM-L90 with Peeler User's Manual

notch

roll paper spacer

inside edge of

the spacer