Epson TM-L90 series Kullanıcı Kılavuzu - Sayfa 15

Etiket makinesi Epson TM-L90 series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Epson TM-L90 series 17 sayfaları. Attaching cover on the power switch
Ayrıca Epson TM-L90 series için: Broşür (1 sayfalar), Broşür (2 sayfalar), Teknik Özellikler (2 sayfalar), Teknik Özellikler (8 sayfalar), Bilgi Kılavuzu (5 sayfalar), Teknik Özellikler (4 sayfalar), Buradan başlayın (2 sayfalar), Buradan başlayın (2 sayfalar), Manuel (13 sayfalar), Talimatlar Kılavuzu (12 sayfalar), Manuel (2 sayfalar)

Slide the roll paper spacer to the appropriate width, as shown above. You can

use the measurement printed inside the printer, aligning the inside edge of

the spacer with the desired measurement.

Width note:

When you want to set the roll paper

width from 61 mm to 70 mm, break off

by hand the two tabs of the spacer

shown in the illustration. (You can

still also use widths from 38 mm to

60 mm with the spacer with the tabs

broken off.)

Insert the screw included with the

spacer into the hole indicated in the

illustration to the right and tighten it.

(Even if you can see two holes, this is

the only one to put the screw in.)

Connecting Cables

To connect cables, first remove the bottom of

the cover as shown in the illustration.

TM-L90 with Peeler User's Manual 11

English

tabs

hole for screw