Philips AZ102S Kullanıcı Kılavuzu - Sayfa 11

Stereo sistemi Philips AZ102S için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Philips AZ102S 15 sayfaları. Cd soundmachine
Ayrıca Philips AZ102S için: Teknik Özellikler (2 sayfalar), Kullanıcı Kılavuzu (14 sayfalar), Kullanıcı Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (15 sayfalar), Kullanıcı Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (18 sayfalar), Kullanıcı Kılavuzu (13 sayfalar), Teknik Özellikler (2 sayfalar), Kullanıcı Kılavuzu (13 sayfalar), Kullanıcı Kılavuzu (1 sayfalar), Servis Kılavuzu (11 sayfalar)

Sayfayı Yazdır

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.

If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING:

Problem

– Possible cause

• Remedy

No sound /power

– Volume not adjusted

• Adjust the VOLUME

– Power cord not securely connected

• Connect the AC power cord properly

– Batteries dead/ incorrectly inserted

• Insert (fresh) batteries correctly

– CD contains non-audio files

• Press ∞ , § once or more to skip to a CD audio

track, instead of the data file.

Display does not function properly / No

reaction to operation of any of the

controls

– Electrostatic discharge

• Switch off and unplug the set. Reconnect after a

few seconds

--, Er or 01 indication

– No CD inserted

• Insert a CD

– CD badly scratched or dirty

• Replace/ clean CD, see Maintenance

– Laser lens steamed up

• Wait until lens has cleared

– CD-R/CD-RW is blank or not finalized

• Use a finalized CD-R/CD-RW or suitable CD

Audio disc only

Do not open the set as there is a risk of electric shock. Under no

circumstances should you try to repair the set yourself, as this will

invalidate the guarantee.

Note:

Make sure the CD is not encoded with copy-

right protection technologies, as some do not

conform to the Compact Disc standard.

The CD skips tracks

– CD damaged or dirty

• Replace or clean CD

– Program/shuffle is active

• Quit program/shuffle mode

Note: A CD badly scratch or dirty may result in

improper operation.