Philips BTM630 Kullanıcı Kılavuzu - Sayfa 19

Stereo sistemi Philips BTM630 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Philips BTM630 34 sayfaları. Bluetooth wireless micro system
Ayrıca Philips BTM630 için: Teknik Özellikler (2 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Kullanıcı Kılavuzu (35 sayfalar), Teknik Özellikler (2 sayfalar), Şartname Sayfası (2 sayfalar), Teknik Özellikler (2 sayfalar), Manuel (34 sayfalar)

Sayfayı Yazdır
Philips BTM630 Kullanıcı Kılavuzu

Tuning to radio stations

1
Press SOURCE repeatedly (or TUNER on the
remote control) to select the tuner source (FM
or AM).
2
Hold
/
on the system (or
S
T
the remote control) and then release the button.
➜
The system will start searching for a radio
station with sufficient signal strength.
3
Repeat step 3 if necessary until you find the
desired station.
●
To tune to a weak station, press
5 /6
the system (or
briefly and repeatedly until you have found
optimal reception.
5 /6
on
/
on
S
T
on the remote control)

Radio Reception

Programming radio stations

You can store up to a total of 40 radio stations
(30 for FM and 10 for AM) in the memory.

Automatic programming

Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1
Press ALBUM • PRESET +/- on the system
(or ¡ / ™ on the remote control) to select the
preset number where programming should start.
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROG on the system (or PROG/
CLOCK on the remote control) for more than
two seconds to activate programming.
➜
All available stations are programmed.

Manual programming

1
Tune to your desired station (refer to "Tuning to
radio stations").
2
Press PROG on the system (or PROG/
CLOCK on the remote control) to activate
programming.
➜
PROG flashes in the display.
3
Press ALBUM • PRESET +/- on the system
(or 3 / 4 on the remote control) to allocate a
number from 1 to 40 to this station.
4
Press PROG on the system (or PROG/
CLOCK on the remote control) again to
confirm the setting.
➜
PROG disappears, the preset number and
the frequency of the preset station are shown.
5
Repeat the above four steps to store other
stations.
●
You can override a preset station by storing
another frequency in its place.

Tuning to preset radio stations

●
Press ALBUM • PRESET +/- on the system
(or 3 / 4 on the remote control) until the
desired preset station is displayed.
19