Toshiba TDP-FF1AU Kullanıcı El Kitabı - Sayfa 22
Projektör Toshiba TDP-FF1AU için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Toshiba TDP-FF1AU 48 sayfaları. Svga 800 x 600
Ayrıca Toshiba TDP-FF1AU için: Teknik Özellikler (2 sayfalar), Teknik Özellikler (2 sayfalar)
Using the remote control
Changing the new lithium battery
Remove the battery compartment.
Insert the battery compartment.
Operating the remote control
Turn on the projector and then the remote control can be used to adjust the OSD,
volume, and input select.
Note
• The remote control is shipped with a plastic sheet between the battery and its contact.
Pull on the sheet to remove it from the remote control.
• Remove the battery from the remote control when it will not be used for an extended
period.
Battery
• Before using the battery, please refer to the notes on
• If the remote control stops working, or if its range decreases, replace the battery with new
one.
The remote control
• The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
• Do not drop or bang it.
• Do not leave it in hot or humid locations.
• Do not get it wet or place on top of wet objects.
• Do not take it apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If this
happens, point the remote control at the main unit again, and repeat the operation.
Replace the lithium battery.
Be sure to align the battery according to
the polarity.
.
22