3Com LANplex 6000 Kurulum Kılavuzu - Sayfa 5

Kablosuz Erişim Noktası 3Com LANplex 6000 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 3Com LANplex 6000 16 sayfaları. 11 mbps wireless lan access point 6000
Ayrıca 3Com LANplex 6000 için: Veri Sayfası (2 sayfalar)

Sayfayı Yazdır

To remove the faceplate:

1 Unscrew the securing screws on the module's faceplate. See Figure 1.

Figure 1 LANplex 6004 with Blank Faceplates

2 Pull the faceplate away from the system.

You can replace a module while the system is powered on. Replacing the

Read if replacing

a TRSM

module requires that you remove the attached cables from the module's

ports prior to installing the new module.

NOTE: Ensure that there is a record of where the cables are attached so that

you can correctly re-connect them to the new module.

CAUTION: Inserting and extracting a TRSM erases all information stored in

NVRAM on the TRSM. Before removing the installed TRSM, save all

nonvolatile data using the NV data save functionality on the system's

Administration Console. This information can be restored using the NV

restore functionality. See the LANplex 6000 Administration Console User

Guide for information on saving, restoring, and resetting nonvolatile data.

Inserting and extracting a module will cause a warm system reboot.

To remove a module:

1 Discharge yourself of static electricity by placing the ESD wrist strap on your

wrist and clipping the alligator clip to the mounting screw located next to

the black ground symbol on the system's right mounting bracket. See

Figure 3. If your system does not have mounting brackets, touch the rear

panel.

2 Disconnect the cables from the module's ports.

3 Unscrew the securing screws on the module's faceplate. See Figure 1.

TRSM Installation

Captive screws

Blank faceplates

LMM+ in slot 1