Cruise N Comfort HD Series Kullanıcı El Kitabı - Sayfa 2

Klima Cruise N Comfort HD Series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Cruise N Comfort HD Series 4 sayfaları.

Tips and Tricks

Here are a couple tips and tricks that will help you get more out of your CNC unit:

• Use the vehicle's A/C to help cool the area down. The a/c unit on your van or vehicle is a lot larger in

capacity than your CNC unit. By pre-cooling the area, the CNC unit has an easier time maintaining the

desired comfort level.

• If the unit cools down the area but the thermostat turns the unit back on immediately after shutoﬀ or never

shuts it oﬀ: The air conditioner is operating correctly. It is possible that the insulation in the area being

cooled is not enough to maintain the temperature in the area.

• Our A/C units will take a long time to cool a hot area that has been sitting in the sun. To help the CNC unit

cool down the area to be cooled, start the engine and run the factory A/C until desired temperature is

reached. If the area to be cooled is pre-cooled, then it will maintain a comfortable temperature depending

on solar load & ambient temperature.

• To prevent the unit from icing in high temperature and high humid environments, do not run the unit at low

blower speeds. Increase blower speeds and set thermostats at reasonable, attainable temperatures.

Freezing evaporators can be a sign of too much ducting, not enough vents, or low refrigerant freon charge.

• Divide the front driving area, rear doors, and/or the sleeping area with a heavy curtain. This, along with

insulated window shades, helps to keep the heat out of the area that is desired to be cooled. Remember,

even though the mid section of a vehicle may be well insulated, usually the driving area is not.

• Mount the thermostat mid-height in the vehicle and near the return air so you get more of an accurate

reading (like in your home). Also avoid mounting the thermostat to an outside wall. It will get a false reading

from a warm wall.

• Park in the shade as much as possible. This will make a big diﬀerence on how easy it is to cool the area.

• When possible, park the vehicle facing east or west, this will decrease the surface area that is heated by

the sun.

• Make sure your batteries are full. The higher the voltage, the more the unit cools (i.e., 12.8 VDC vs.13.8

VDC).

• Insulating the vehicle is very important. Invest in a thermal imaging camera for your smartphone. These

cameras are fairly inexpensive and can help you see where your vehicle needs better insulation.

• Current consumptions are nominal. The units can draw more in hot climates or when installed improperly,

and they can draw less in cooler climates.

• If unit shows sign of malfunction, please stop using the product immediately and call Cruise N Comfort

USA right away at (855)899-1442.