Cruise N Comfort HD Series Kullanıcı El Kitabı - Sayfa 3

Klima Cruise N Comfort HD Series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Cruise N Comfort HD Series 4 sayfaları.

Maintenance

• Periodically check inside evaporator ﬁns and remove any dirt, hair and other debris. this can be removed

using a combination of a soft brush, compressed air, lint brush, and/or a shop vacuum. Caution: do not stick

anything into the evaporator blower- serious injury or death could result. Always wear eye protection when

working around or servicing blower or vents with above methods.

• Check outside condenser fans for proper air ﬂow (air should be felt ﬂowing from a safe distance). Caution:

do not stick anything into the fans- serious injury or death could result. Always wear eye protection when

working around or servicing condenser fans with above methods.

• Outside condenser ﬁns can be cleaned with a pressure washer, hose, or compressed air. Always wear eye

protection when cleaning condenser with above methods.

• Check around inside unit for condensation and check drain tray tubes to make sure they are clear and able

to evacuate condensation.

Troubleshooting

• Unit is not blowing cold air

Solution

• Check to make sure manual control has the switch to "On" position or thermostat is set to "Cool".

• Check operation of outside fans, inside blower, and compressor. When initially turned on, the outside

condenser fans and inside evaporator blower will turn on. The compressor will turn on in approximately 30

seconds. To better hear the compressor, turn the evaporator blower to low speed before starting system.

• If you hear all 3 of the above operating, then the system could be low on refrigerant. Have the system

evacuated, checked for leaks, and recharged with appropriate refrigerant based on the installation manual

requirements. Do not add any leak sealants or unapproved leak dyes. Call Cruise N Comfort USA Tech

Support for appropriate leak dye. Leaks in hoses or hose connections can be seen while unit is running by

spraying a soapy water solution onto ﬁtting and checking for bubbles. Leaks may also be evident by

inspecting condenser and hose connections and looking for oil residue.

• If the inside evaporator fan turns on but there is no ﬂow, the evaporator could have iced up due to low air

ﬂow in high humidity conditions and/or is low on refrigerant. Turn unit oﬀ for an extended period of time and

run the the blower only mode (on thermostat equipped models). Return to normal operation after unit has

thawed.

• You may also determine if the unit is low on refrigerant by looking for bubbles or liquid in the sight glass on

the receiver dryer. The receiver dryer is a black cylinder with a round sight glass on top located next to the

compressor on HD/MES models. On the VES systems it is inline in between the condenser and the #6

evaporator hose. During operation, bubbles should not be evident after 15 minutes of operation. If the unit

has bubbles, have the system evacuated, checked for leaks, and recharge with appropriate refrigerant based

on the installation manual requirements.

• If outside condenser fans are not turning, turn oﬀ unit immediately and check fuses to make sure they are not

blown and check breakers for fault. If this is the case, check the power wire going to fans for a short and

check to see if fans are faulty. Call Cruise N Comfort USA for replacements.

Do Not send Cruise N Comfort units back for repairs before ﬁrst obtaining an RMA number via

email. Please email [email protected] before trying to obtain warranty work.