Crunch GTX 750 Kullanıcı El Kitabı - Sayfa 15
Amplifikatör Crunch GTX 750 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Crunch GTX 750 20 sayfaları. Gravity series class a/b mono car audio amplifiers
Ayrıca Crunch GTX 750 için: Kullanıcı El Kitabı (20 sayfalar)
Sayfayı Yazdır
G T X 7 5 0 _ G T X 1 2 0 0
1
POWER/PROTECT (Also located on the Bass Remote unit)
1
If the POWER LED lights up, the amplifier is ready for operation.
If the PROTECT LED lights up, a malfunction is indicated. Attend in this case the chapter TROUBLE SHOOTING.
The REMOTE port is for the cable of the enclosed bass remote controller and only to use in the LP/BP mode. With this bass
2
remote controller, you are able to adjust the bass level e.g. out of the driver's seat. Please use only the enclosed bass remote
controller and cable.
The BASS BOOST controller adjusts the bass boost enhancement continuously from 0dB to +12dB at 45 Hz.
3
The SUB SONIC controller (Subsonicfilter) limits the ultralow and not hearable frequencies of the audiosignal to below, to avoid
4
a mechanical and electrical overloading on the subwoofer. The cut-off frequency is adjustable from 15 to 55 Hz and depends on
the size of the subwoofer.
The LOW PASS controller adjusts the cut-off point of the frequency range to above. The cut-off frequency is continuously
5
adjustable from 40 Hz to 150 Hz.
The LEVEL controller adjusts the input sensitivity of the amplifier to align the audio signal from the head unit.
6
The input sensitivity is adjustable from 5 to 0.2 Volts.
The LINE OUTPUT RCA jacks provide a linear fullrange audiosignal to supply an additional amplifier.
7
The LINE INPUT RCA jacks must be connected with the RCA output jacks of the headunit.
8
FUNCTIONS AND OPERATIONAL CONTROLS
2
3
4
5
6
7
1 5
8