Dimplex ELECTRALOG CS1205 Servis Kılavuzu - Sayfa 12
Soba Dimplex ELECTRALOG CS1205 için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Dimplex ELECTRALOG CS1205 16 sayfaları. Electric stove
Ayrıca Dimplex ELECTRALOG CS1205 için: Kullanıcı El Kitabı (12 sayfalar), Kullanıcı El Kitabı (11 sayfalar), Kullanıcı El Kitabı (11 sayfalar)
Sayfayı Yazdır
- 1. Table of Contents
- 2. Operation
- 3. Replacement Parts
- 4. Wiring Diagram
- 5. To Replace Light Bulbs
- 6. To Replace Lampholders
- 7. To Replace On/Off and Heater Switches
- 8. To Replace Heater Assembly
- 9. To Replace Terminal Block
- 10. To Replace Flame Motor/Flame Rod
- 11. To Replace the Power Cord
- 12. Troubleshooting Guide
CS1205
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE FLAME MOTOR/FLAME ROD
1. Remove the 8 fastening screws on the top panel and remove the top of the stove.
2. Lift glass out and store in a safe place.
3. Remove the log set by sliding to the rear of the stove and lifting out.
4. Remove the reflector rod from the flame motor by pulling the end of the rod to the
left and separating it from the rubber sleeve.
5. Remove the rubber sleeve from the motor shaft.
6. Remove the 2 motor mounting screws and remove the flame motor.
7. Discard the old flame motor.
8. Lay the stove on its back with the front window facing upward.
9. Remove the bottom heater assembly cover being careful not to damage any of the
wiring and lay it on the floor.
10. Loosen the flame motor connections on the terminal block and remove the wires
noting their original locations.
11. Reassemble in the reverse order.
11