Aeon Labs Aeotec Water Sensor 6 Manuel - Sayfa 9

Aksesuarlar Aeon Labs Aeotec Water Sensor 6 için çevrimiçi göz atın veya pdf Manuel indirin. Aeon Labs Aeotec Water Sensor 6 12 sayfaları. Z-wave water sensor

Sayfayı Yazdır
Parameter Number Definitions (8 bit):
Parameter
Description
Number
Hex/
Decimal
0x02 (2)
Enable/disable wake up for 10 minutes state when re-power on the
Sensor
0 = Disable,
1 = Enable.
0x08 (8)
Set the timeout to go into the sleep state after the Wake Up
Notification was sent out.
[15, 255]
0x09 (9)
Get the current power mode
Value 1: 0 = USB power, 1 = Battery power.
Value 2: 0 = Sleeping mode after re-power on, 1 = keep awake for 10
minutes after re-power on, 2 = always awake state.
Note: This parameter is a Get-only parameter.
0x0A (10)
Set the alarm time for the Buzzer when the sensor is triggered.
Value 1: the time of Buzzer keeping OFF state (MSB)
Value 2: the time of Buzzer keeping OFF state (LSB)
Value 3: the time of Buzzer keeping ON state (MSB)
Value 4: repeated cycle of Buzzer alarm.
Note: one cycle is equal to the Buzzer from ON state to OFF state.
0x27 (39)
Set the low battery value.
Range: 10% to 50%.
0x30 (48)
Enable/disable the sensor report
Bit =0, the corresponding sensor report is disabled.
Bit =1, the corresponding sensor report is enabled.
0x31 (49)
Set the upper limit value (overheat).
Value 1: temperature value (MSB)
Value 2: temperature value (LSB)
Value 2: 0 = Celsius unit, 1 = Fahrenheit unit.
Value 4: reserved.
0x32 (50)
Set the lower limit value (under heat).
Value 1: temperature value (MSB)
Value 2: temperature value (LSB)
Value 2: 0 = Celsius unit, 1 = Fahrenheit unit.
Value 4: reserved.
0x39 (57)
Set the recover limit value of temperature sensor.
Note:
1.
When the current measurement <= (Upper limit – Recover limit),
the upper limit report is enabled and then it would send out a
sensor report when the next measurement is more than the
upper limit. After that the upper limit report would be disabled
again until the measurement <= (Upper limit – Recover limit).
Configuration Value n(LSB)
Page 9
Default Value
Size
0
1
30
1
-
2
0x001E0A0A
4
20
1
1
1
US version:
4
0x04100100 (104
℉
) .
Other versions:
0x01900000 (40
) .
℃
US version:
4
0x01400100 (32
℉
) .
Other versions:
0x00000000 (0
℃
) .
US version:
2
0x1401(2.0
℉
)
Other version:
0x1400 (2.0
℃
)