Pioneer DEH-10MP Kullanıcı El Kitabı - Sayfa 13

Araç Alıcısı Pioneer DEH-10MP için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer DEH-10MP 26 sayfaları.

Sayfayı Yazdır

( Connections

~Important

•

When this unit is installed in a vehicle without

ACC (accessory) position on the ignition

switch, red cable must be wired to the term-

inal that can detect the operation of the igni-

tion key. Otherwise, battery drain may result.

:::J

iii'

:::r

section

)(1

•

Control signal is output through blue/white

cable when this unit is powered on. Connect it

to an external power amp's system remote

control or the vehicle's auto-antenna relay

control terminal (max. 300 mA 12 V DC). If the

vehicle is equipped with a glass antenna, con-

nect it to the antenna booster power supply

terminal.

•

Never connect blue/white cable to external

power amp's power terminal. Also, never con-

nect it to the power terminal of the auto anten-

na. Otherwise, battery drain or malfunction

may result.

•

Black cable is ground. This cable and other

product's ground cable (especially, high-cur-

rent products such as power amp) must be

wired separately. Otherwise, fire or malfunc-

tion may result if they are accidentally de-

tached.

No ACC position

ACC position

•

Use of this unit in conditions other than the

following could result in fire or malfunction.

Vehicles with a 12-volt battery and negative

grounding.

Speakers with 50 W (output value) and 4

ohm to 8 ohm (impedance value).

• To prevent a short-circuit, overheating or mal-

function, be sure to follow the directions

below.

Disconnect the negative terminal of the

battery before installation.

Secure the wiring with cable clamps or ad-

hesive tape. To protect the wiring, wrap ad-

hesive tape around them where they lie

against metal parts.

Place all cables away from moving parts,

such as gear shift and seat rails.

Place all cables away from hot places,

such as near the heater outlet.

Do not pass the yellow cable through a

hole into the engine compartment to con-

nect to a battery.

Cover any disconnected cable connectors

with insulating tape.

Do not shorten any cables.

Never cut the insulation of the power cable

of this unit in order to share the power

with other devices. Current capacity of the

cable is limited.

Use a fuse of the rating prescribed.

Never wire the speaker negative cable di-

rectly to ground.

Never band together multiple speaker's ne-

gative cables.