Pioneer DEH-10MP 소유자 매뉴얼 - 페이지 13
{카테고리_이름} Pioneer DEH-10MP에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Pioneer DEH-10MP 26 페이지.
페이지 인쇄
( Connections
~Important
•
When this unit is installed in a vehicle without
ACC (accessory) position on the ignition
switch, red cable must be wired to the term-
inal that can detect the operation of the igni-
tion key. Otherwise, battery drain may result.
-
m
:::J
CC
-
iii'
:::r
section
)(1
•
Control signal is output through blue/white
cable when this unit is powered on. Connect it
to an external power amp's system remote
control or the vehicle's auto-antenna relay
control terminal (max. 300 mA 12 V DC). If the
vehicle is equipped with a glass antenna, con-
nect it to the antenna booster power supply
terminal.
•
Never connect blue/white cable to external
power amp's power terminal. Also, never con-
nect it to the power terminal of the auto anten-
na. Otherwise, battery drain or malfunction
may result.
•
Black cable is ground. This cable and other
product's ground cable (especially, high-cur-
rent products such as power amp) must be
wired separately. Otherwise, fire or malfunc-
tion may result if they are accidentally de-
tached.
No ACC position
ACC position
•
Use of this unit in conditions other than the
following could result in fire or malfunction.
-
Vehicles with a 12-volt battery and negative
grounding.
-
Speakers with 50 W (output value) and 4
ohm to 8 ohm (impedance value).
• To prevent a short-circuit, overheating or mal-
function, be sure to follow the directions
below.
-
Disconnect the negative terminal of the
battery before installation.
-
Secure the wiring with cable clamps or ad-
hesive tape. To protect the wiring, wrap ad-
hesive tape around them where they lie
against metal parts.
-
Place all cables away from moving parts,
such as gear shift and seat rails.
-
Place all cables away from hot places,
such as near the heater outlet.
-
Do not pass the yellow cable through a
hole into the engine compartment to con-
nect to a battery.
-
Cover any disconnected cable connectors
with insulating tape.
-
Do not shorten any cables.
-
Never cut the insulation of the power cable
of this unit in order to share the power
with other devices. Current capacity of the
cable is limited.
-
Use a fuse of the rating prescribed.
-
Never wire the speaker negative cable di-
rectly to ground.
-
Never band together multiple speaker's ne-
gative cables.
En
@)