Pioneer DVH-340UB Kurulum Kılavuzu - Sayfa 3

Alıcı Pioneer DVH-340UB için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Pioneer DVH-340UB 41 sayfaları. Dvd rds receiver
Ayrıca Pioneer DVH-340UB için: Hızlı Başlangıç Kılavuzu (17 sayfalar), Kullanım Kılavuzu (45 sayfalar)

Sayfayı Yazdır

Connections

Power cable connection

Note:

Depending on the kind of vehicle, the

function of 2* and 4* may be different. In

this case, be sure to connect 1* to 4*

and 3* to 2*.

Yellow (2*)

Yellow (1*)

Back-up (or

Connect to the constant

accessory)

12 V supply terminal.

Red (4*)

Red (3*)

Accessory

Connect to terminal controlled

(or back-up)

by ignition switch (12 V DC).

Black (chassis ground)

Connect to a clean, paint-free metal location.

ISO connector

Note:

In some vehicles, the ISO connector

may be divided into two. In this case,

be sure to connect to both connectors.

Connect leads of the same

color to each other.

Speaker leads

Front left 

White:

White/black: Front left 

Front right 

Gray:

Gray/black: Front right 

Rear left or subwoofer 

Green:

Green/black: Rear left or subwoofer 

Rear right  or subwoofer 

Violet:

Violet/black: Rear right or subwoofer

Connections

Wired remote input

Hard-wired remote control

adapter can be connected

(sold separately).

Antenna jack

Fuse (10 A)

Notes:

Change the initial setting of this unit (refer to the

Operation Manual). The subwoofer output of this

unit is monaural.

When using a subwoofer of 70 W (2 Ω), be sure

to connect the subwoofer to the violet and

violet/black leads of this unit. Do not connect

anything to the green and green/black leads.

This product

Yellow/black

If you use an equipment with Mute function, wire

this lead to the Audio Mute lead on that equipment.

If not, keep the Audio Mute lead free of any

connections.

Blue/white

Connect to system control terminal of the

power amp (max. 300 mA 12 V DC).

Blue/white (6*)

Blue/white (5*)

Connect to auto-antenna

relay control terminal

(max. 300 mA 12 V DC).

The pin position of the ISO connector will differ

depends on the type of vehicle. Connect 5* and

6* when Pin 5 is an antenna control type. In

another type of vehicle, never connect 5* and 6*.

Section