Pioneer AVH-P7950DVD Kurulum Kılavuzu - Sayfa 16
Stereo Alıcı Pioneer AVH-P7950DVD için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Pioneer AVH-P7950DVD 40 sayfaları.
Sayfayı Yazdır
Installation
Note:
•
Check all connections and systems before final
installation.
•
Do not use unauthorized parts. The use of
unauthorized parts may cause malfunctions.
•
Consult with your dealer if installation requires
drilling of holes or other modifications of the
vehicle.
•
Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
•
Do not install the display where it may (i)
obstruct the driver's vision, (ii) impair the per-
formance of any of the vehicle's operating sys-
tems or safety features, including air bags, haz-
ard lamp buttons or (iii) impair the driver's abili-
ty to safely operate the vehicle.
•
The semiconductor laser will be damaged if it
overheats. Install this unit away from hot places
such as near the heater outlet.
•
Optimum performance is obtained when the unit
is installed at an angle of less than 30°.
•
Make sure you leave enough gap between the
dashboard and the LCD panel of this unit so the
LCD panel can be opened and closed without
contacting with the dashboard.
Dashboard
Leave gap
LCD panel
15
16
ENG/MASTER 96 INST
•
The cords must not cover up the area shown in
the figure below. This is necessary to allow the
amplifires to radiate freely.
Hide-away unit
•
When installing make sure you leave ample
space (approx. 10 cm) in front of the exhaust fan
outlet.
•
When installing, to ensure proper heat dispersal
when using this unit, make sure you leave ample
space behind the rear panel and wrap any loose
cables so they are not blocking the vents.
•
When mounting the hide-away unit, make sure
none of the leads are trapped between the hide-
away unit and the surrounding metalwork or fit-
tings.
•
Do not mount the hide-away unit near the heater
outlet, where it would be affected by heat, or
near the doors, where rainwater might splash
onto it.
•
Before drilling any mounting holes always check
behind where you want to drill the holes. Do not
30°
drill into the gas line, brake line, electrical
wiring or other important parts.
•
If the hide-away unit is installed in the passenger
compartment, anchor it securely so it does not
break free while the car is moving, and cause
Fig. 9
injury or an accident.
•
If the hide-away unit is installed under a front
seat, make sure it does not obstruct seat move-
ment. Route all leads and cords carefully around
the sliding mechanism so they do not get caught
or pinched in the mechanism and cause a short
circuit.
•
Follow the instructions below when installing
the power supply box.
— Keep the power supply box as far away as
possible from any antenna cable.
— Do not install the power supply box where it
might obstruct safe driving.
Fig. 10
Do not cover this area.
Fig. 11
<CRD4229-A> 16