Pioneer VSX94TXH - Elite AV Receiver Talimatlar Kılavuzu - Sayfa 6
Stereo Alıcı Pioneer VSX94TXH - Elite AV Receiver için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Pioneer VSX94TXH - Elite AV Receiver 8 sayfaları. Elite a/v receiver firmware update instructions for hdmi, dsp, event, and main microcomputers, dsp1 & dsp2 flash rom
Ayrıca Pioneer VSX94TXH - Elite AV Receiver için: Teknik Özellikler (2 sayfalar), Kullanım Talimatları Kılavuzu (19 sayfalar)
Sayfayı Yazdır
MAIN microcomputer:
1. Follow the steps under "I. HDMI, DSP, EVENT, and MAIN microcomputers", "Preparations:" on page 2.
2. Enter Service Mode by holding the "ENTER" (21) and then the "MULTI- ZONE ON/OFF" (15) keys together for about
3 seconds.
3. Within 4 seconds press the
4. Within 4 seconds press the "ENTER" (21) key and "MAIN DL [GO ON]" is displayed.
Open the UFU.exe program and select "Full" in "Mode Select" box. Click on the "File Selection" button.
5.
6. Select the latest MAIN u-com firmware file (Example: 07MID_main_1006(071011).mot). Check Pioneer's ASC
website for the latest firmware files.
7. Select communication port/speed and format:
•
Select the COM Port. This must match the available COM port on your PC. Ex: COM 1
Note: If
"Target device is
for the correct type, cable connections, and COM port settings on your PC.
•
Base speed: 19,200.
•
Data Send speed: 57,600 or 19,200. Try 57,600 first as this will shorten the upgrade time.
•
Transmission format: "S"
8.
Click on the "START" button.
The UFU software will check the communication and baud rate between the PC and AV receiver and then downloading
should start in a few seconds. If the update failed after the "Erasing FLASH memory" the unit may remain stuck
"MAIN DL [GO ON]" mode. Follow the "MAIN microcomputer Firmware Forcible Update Procedure" on pg. 8.
9.
When finished "Update complete" is shown in the "Update Information" box and the receiver will turn off then back on.
This can take up to 12 minutes.
Note: If you want to upgrade another unit with the same firmware. Just click "START" again. Click "EXIT' when you
want to change to different firmware or have finished with all the updates.
10.
Disconnect the receiver's AC for 10 seconds and then reconnect it. Exit the UFU.exe program.
11.
Check the version. See page 7.
(21) key to select "MAIN DL [START]".
connected" is not shown in the "Update Information" box, check the RS232c cable
6
Pioneer Electronics Service, Inc
SE Dept, QA Division
Rev date: 07/02/2008