Pioneer A-607R Servis Kılavuzu - Sayfa 27

Amplifikatör Pioneer A-607R için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Pioneer A-607R 29 sayfaları. Stereo amplifier

Sayfayı Yazdır

REC SELECTOR switch /indicator(For TAPE 1/MD

terminals)

This switch is used to select the recording source component.

The signal from the selected component is output at the TAPE1/

MD jacks for recording. To select a recording source compo-

nent, press the REC SELECTOR switch so that the indicator of

the desired source component lights up. When this switch is set

to [TUNER] or [CD], the signal from the selected component

can be recorded regardless of the input selector switch and

TAPE2 MONITOR button settings.

: To record from the equipment connected to the CD

terminals.

TUNER : To record from the equipment connected to the

TUNER terminals.

SOURCE : To record from the equipment selected by the IN-

PUT SELECTOR knob.

OFF

: In this position, nothing from the REC terminals of

TAPE 1/MD is output. Set to this position when not

recording; the cassette deck will be disconnected,

improving sound quality.

NOTE:

The function selected using the INPUT SELECTOR knob will

be recorded irrespective of the position of the REC SELECTOR

switch (TAPE 2 MONITOR terminals).

BALANCE control

Should normally be left in the center position. Adjust the bal-

ance if the sound is louder from one of the speakers. If the right

side is louder, turn toward the L (left) position and if the left side

is louder, turn toward the R (right) position.

NOTE:

This control does not operate when the DIRECT button is in the

on position.

0 DIRECT button/indicator

Use this button when you do not wish to pass the output from

input terminal equipment through the various frequency adjust-

ing circuits (BASS, TREBLE, BALANCE, LOUDNESS).

On : The indicator lights. The signals input through the input

terminals are reproduced without passing through the

various frequency adjusting circuits. This results in flat,

pure sound which is a more faithful reproduction of the

input source.

Off : The indicator goes out. The signal passes through the

various frequency adjusting circuits.

LOUDNESS button/indicator

Use when listening at low volume level.

On : The indicator lights. Boosts low and high frequencies to

give added punch to playback even at low volume level.

Off : The indicator goes out. Should normally be left in this

position.

NOTE:

This button does not operate when the DIRECT button is in the

on position.

TREBLE tone control

Use to adjust the high-frequency tone. The center position is the

flat (normal) position. When turned to the right, the high-frequency

tone is emphasized; when turned to the left, the high-frequency

tone is de-emphasized.

NOTE:

This control does not operate when the DIRECT button is in the

on position.

BASS tone control

Use to adjust the low-frequency tone. The center position is the

flat (normal) position. When turned to the right, the low-frequency

tone is emphasized; when turned to the left, the low-frequency

tone is de-emphasized.

NOTE:

This control does not operate when the DIRECT button is in the

on position.

PHONES jack

When using headphones, insert the plug into this jack.

SPEAKERS B (ON/OFF) button/indicator

Use this button to listen to the speaker system connected to the

SPEAKERS B terminals.

On : The indicator lights. Sound is heard from the speaker

system.

Off : The indicator goes out. No sound is heard from the

speaker system. Set to this position when listening with

headphones.

SPEAKERS A (ON/OFF) button/indicator

Use this button to listen to the speaker system connected to the

SPEAKERS A terminals.

On : The indicator lights. Sound is heard from the speaker

system.

Off : The indicator goes out. No sound is heard from the

speaker system. Set to this position when listening with

headphones.

A-607R