Pioneer GM-A4704 Kullanıcı El Kitabı - Sayfa 13

Amplifikatör Pioneer GM-A4704 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Pioneer GM-A4704 19 sayfaları. Bridgeable four-channel power amplifier
Ayrıca Pioneer GM-A4704 için: Kullanıcı El Kitabı (33 sayfalar)

Sayfayı Yazdır
Pioneer GM-A4704 Kullanıcı El Kitabı
(Connecting the units
)
Connecting the speaker
output terminals
1
Use wire cutters or a utility knife to
strip the end of the speaker wires to ex-
pose about 10 mm (3/8 in.) of wire and
then twist the wire.
Twist
r-r
10
mm
(3/8 inch)
2
Attach lugs to wire ends.
Use pliers, etc., to crimp lugs to wires.
/D
CD
Lug (sold separately)
W
Speaker wire
3
Connect the speaker wires to the
speaker output terminals.
Fix the speaker wires securely with the term-
inal screws.
~~
CD
Terminal screws
W
Speaker wires
G) Speaker output terminals[!]
En
( Installation
)
Before installing the amplifier
AwARNING
·
•
To ensure proper installation, use the supplied
parts in the manner specified. If any parts
other than those supplied are used, they may
damage internal parts of the amplifier, or be-
come loose causing the amplifier to shut
down.
•
Do not install in:
-
Places where it could injure the driver or
passengers if the vehicle stops suddenly.
-
Places where it may interfere with the dri-
ver, such as on the floor in front of the dri-
ver's seat.
•
Install tapping screws in such a way that the
screw tip does not touch any wire. This is im-
portant to prevent wires from being cut by vi-
bration of the car, which can result in fire.
•
Make sure that wires do not get caught in the
sliding mechanism of the seats or touch the
legs of a person in the vehicle as short-circuit
may result.
•
When drilling to install the amplifier, always
confirm no parts are behind the panel and
protect all cables and important equipment
(e.g. fuel/brake I i nes, wiring) from damage.
A
cAUTION
•
To ensure proper heat dissipation of the amp I i-
fier, ensure the following during installation:
-
Allow adequate space above the amplifier
for proper venti I at ion.
-
Do not cover the amplifier with a floor mat
or carpet.
•
Protection function may activate to protect the
amplifier against overheating due to installa-
tion in locations where sufficient heat cannot
be dissipated, continuous use under high-vo-
lume conditions, etc. In such cases, the am-
pi ifier reduces the power output or shuts
down until it has cooled to a certain desig-
nated temperature.
•
Place all cables away from hot places, such
as near the heater outlet.
•
The optimal installation location differs de-
pending on the car model. Secure the ampli-
fier at a sufficiently rigid location.