Pioneer GM-A4704 Посібник користувача - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Pioneer GM-A4704. Pioneer GM-A4704 19 сторінок. Bridgeable four-channel power amplifier
Також для Pioneer GM-A4704: Посібник користувача (33 сторінок)

Друкувати сторінку

(Connecting the units

)

Connecting the speaker

output terminals

Use wire cutters or a utility knife to

strip the end of the speaker wires to ex-

pose about 10 mm (3/8 in.) of wire and

then twist the wire.

Twist

r-r

(3/8 inch)

Attach lugs to wire ends.

Use pliers, etc., to crimp lugs to wires.

Lug (sold separately)

Speaker wire

Connect the speaker wires to the

speaker output terminals.

Fix the speaker wires securely with the term-

inal screws.

Terminal screws

Speaker wires

G) Speaker output terminals[!]

( Installation

)

Before installing the amplifier

AwARNING

•

To ensure proper installation, use the supplied

parts in the manner specified. If any parts

other than those supplied are used, they may

damage internal parts of the amplifier, or be-

come loose causing the amplifier to shut

down.

•

Do not install in:

Places where it could injure the driver or

passengers if the vehicle stops suddenly.

Places where it may interfere with the dri-

ver, such as on the floor in front of the dri-

ver's seat.

•

Install tapping screws in such a way that the

screw tip does not touch any wire. This is im-

portant to prevent wires from being cut by vi-

bration of the car, which can result in fire.

•

Make sure that wires do not get caught in the

sliding mechanism of the seats or touch the

legs of a person in the vehicle as short-circuit

may result.

•

When drilling to install the amplifier, always

confirm no parts are behind the panel and

protect all cables and important equipment

(e.g. fuel/brake I i nes, wiring) from damage.

cAUTION

•

To ensure proper heat dissipation of the amp I i-

fier, ensure the following during installation:

Allow adequate space above the amplifier

for proper venti I at ion.

Do not cover the amplifier with a floor mat

or carpet.

•

Protection function may activate to protect the

amplifier against overheating due to installa-

tion in locations where sufficient heat cannot

be dissipated, continuous use under high-vo-

lume conditions, etc. In such cases, the am-

pi ifier reduces the power output or shuts

down until it has cooled to a certain desig-

nated temperature.

•

Place all cables away from hot places, such

as near the heater outlet.

•

The optimal installation location differs de-

pending on the car model. Secure the ampli-

fier at a sufficiently rigid location.