Pioneer CLD-DS04 Kullanım Talimatları Kılavuzu - Sayfa 4
CD Çalar Pioneer CLD-DS04 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Pioneer CLD-DS04 30 sayfaları. Cd cdv ld player
Sayfayı Yazdır
PRECAUTIONS
If it becomes
necessary
to transport
or ship this unit in the
future, be sure to first remove the disc (if loaded), and retract
the disc table to its closed position.
Then turn the power off,
and, after the "OFF" display stops blinking on the display, dis-
connect the power cord.
When FM or AM stations are being received, signal noise may be
generated
if the player is turned on. Turn off the player when not
in use. Also, if there is signal noise when receiving radio stations
with
an indoor antenna,
adjust the position
or direction
of the
antenna.
INSTALLING
THE PLAYER
•
Place the player on a stable platform next to the television
and
stereo system to be used with the player.
•
Do not place heavy objects
such as a television
or TV monitor
on top of the player.
•
Do not place the player on top of your TV set or TV monitor.
Also, keep the player away from devices such as cassette decks
which are sensitive to magnetic fields.
DO
NOT
INSTALL
THE
PLAYER
IN THE
FOLLOWING
LOCATIONS
•
In a place subject to direct sunlight.
•
In humid or poorly ventilated places.
•
In extremely
hot or cold places.
•
In a place subject to vibrations.
•
In a dusty place.
•
In a place subject to soot, steam or heat (in a kitchen, etc.)
AVOID
SOURCES
OF HEAT
Do not put the player on sources
of heat, such as an amplifier.
When installing
with audio components
that generate
heat, by
placing the player below
such components
where there is ade-
quate ventilation
and not much dust. Avoid placing the player on
surfaces such as shaggy carpets, beds, and sofas which may block
ventilation
under the player and cause damage.
CAUTION
Even when the player is in the pause mode, the disc-drive motor is
still revolving. Since leaving the player in this condition can shorten
the lifetime
of the motor, do not leave the player in the pause
mode for long periods of time. Also, to prevent
damage to the
screen, do not use the unit for long periods of time under condi-
tions in which the screen display (monitor) is displaying characters
(for example,
power-ON mode, CD PLAYER, PAUSE) With an LD
disc, if playback
is paused for about 20 minutes,
the player will
automatically
enter stop mode.
STRIPE
PATTERNS
APPEARING
ON A TV PROGRAM
Stripe patterns may appear during a TV program if the player unit is
turned on, depending on the quality of reception of the TV station.
This is neither
a malfunction
of the television
nor the player. If
stripes appear while watching
the TV, or whin watching
the TV for
long periods of time, turn the player off.
CONDENSATION
Moisture
will form in the operating
section of the player if the
player is brought from cool surroundings
into a warm room or
if the temperature
of the room rises suddenly. When this hap-
pens, player's performance
will be impaired.
To prevent
this, let the player stand in its new •urroundings
for about an hour before switching
it on, or make sure that
the room temperature
rises gradually.
Condensation
may also form during the summer
if the player is
exposed
to the breeze from
an air conditioner.
In such cases,
change the location of the player.
POWER-CORD
CAUTION
Handle the power cord by the plug. Do not pull out the plug by
tugging the cord and never touch the power cord when your hands
are wet as this could cause a short circuit or electric shock. Do not
place the unit, a piece of furniture,
etc., on the power cord, or
pinch the cord. Never make a knot in the cord or tie it with other
cords. The power cords should be routed in such a way that they
are not likely to be stepped on. A damaged power cord can cause
a fire or give you an electrical shock. Check the power cord once in
a while.
When you find it damaged,
ask your nearest
PIONEER
authorized service center or your dealer for a replacement.
I CLEANING CARE I
Use a soft, dry cloth for cleaning. For stubborn dirt, soak the cloth
in a weak detergent
solution; wring well first and wipe. Use a dry
cloth to wipe it dry. Do not use any volatile agents such as benzine
or paint thinner, as they may damage the surface of the player.
Abnormal functioning
of this unit may be caused by static
electricity
or other external interference.
To restore normal
operation,
unplug
the AC power
cord and then plug it in
again.
Only one disc can be loaded at any one time. Loading a Laser-
Disc, a Compact Disc, a 3-inch (8-cm) Compact Disc or a Com-
pact Disc with Video on top of one another may result in a
breakdown,
or in scratching of the di•cs. Please only load one
disc at a time.
This player
is to be used exclu•ively
with
the NTSC color
system. Plea•e use an NTSC LaserDisc only. PAL and SECAM
system discs cannot be used with this player.
4
<VRB1147>