Aeotec Door / Window Sensor 7 Kullanıcı Kılavuzu - Sayfa 6
Aksesuarlar Aeotec Door / Window Sensor 7 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aeotec Door / Window Sensor 7 9 sayfaları.
Ayrıca Aeotec Door / Window Sensor 7 için: Hızlı Başlangıç Kılavuzu (11 sayfalar), Kullanıcı Kılavuzu (9 sayfalar), Kullanıcı Kılavuzu (10 sayfalar)
Sayfayı Yazdır
1.8.2019
You can find direct information in this article here: https://aeotec.freshdesk.com/support/solutions/articles/6000223859
(https://aeotec.freshdesk.com/support/solutions/articles/6000223859)
Scene Controller.
When activated by configuration parameter #13 the device can perform as a scene controller. The external dry contact will then act
as a scene controller with a total of 7 scenes that can be activated:
1. Contact Pressed 1 time
2. Contact Pressed 2 time
3. Contact Pressed 3 time
4. Contact Pressed 4 time
5. Contact Pressed 5 time
6. Contact held down
7. Contact released
You can find out more information on how to use Door / Window Sensor 7 in this article here:
https://aeotec.freshdesk.com/support/solutions/articles/6000223885
(https://aeotec.freshdesk.com/support/solutions/articles/6000223885)
Communication test.
This utilizes the Power Level command class to determine the health between the Door / Window Sensor 7 and your Z-Wave
gateway. This will tell you if the Door / Window Sensor 7 has a healthy connection to your system and is a great method of
debugging connectivity issues.
1. Set Parameter #4 to value #1
2. Double click the Tamper Switch.
3. Result:
Blinks once - success
Blinks 5x times - failure
Firmware-Update over the Air.
This device is capable of receiving a new firmware 'over the air'. The update function needs to be supported by the central controller.
Once the controller starts the update process, perform the following action to confirm the firmware update:
1. Wake Up the device by removing the cover.
2. The hit the tamper switch once.
Send a wake up notification.
In order to send your sensors new configuration commands from your Z-Wave controller or gateway, it will need to be woken up.
1. Wake Up the device by removing the cover.
2. The hit the tamper switch once.
Note: Door / Window Sensor 7 remains awake until the housing is closed again.
Remove your Door / Window Sensor 7 from Z-Wave network.
https://aeotec.freshdesk.com/support/solutions/articles/6000218764-door-windows-sensor-7-user-guide
Door / Window 7 user guide : Aeotec Group
6/9