Aeotec Door / Window Sensor 7 Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Аксесуари Aeotec Door / Window Sensor 7. Aeotec Door / Window Sensor 7 9 сторінок.
Також для Aeotec Door / Window Sensor 7: Посібник із швидкого старту (11 сторінок), Посібник користувача (9 сторінок), Посібник користувача (10 сторінок)

1.8.2019

You can find direct information in this article here: https://aeotec.freshdesk.com/support/solutions/articles/6000223859

(https://aeotec.freshdesk.com/support/solutions/articles/6000223859)

Scene Controller.

When activated by configuration parameter #13 the device can perform as a scene controller. The external dry contact will then act

as a scene controller with a total of 7 scenes that can be activated:

1. Contact Pressed 1 time

2. Contact Pressed 2 time

3. Contact Pressed 3 time

4. Contact Pressed 4 time

5. Contact Pressed 5 time

6. Contact held down

7. Contact released

You can find out more information on how to use Door / Window Sensor 7 in this article here:

https://aeotec.freshdesk.com/support/solutions/articles/6000223885

(https://aeotec.freshdesk.com/support/solutions/articles/6000223885)

This utilizes the Power Level command class to determine the health between the Door / Window Sensor 7 and your Z-Wave

gateway. This will tell you if the Door / Window Sensor 7 has a healthy connection to your system and is a great method of

debugging connectivity issues.

1. Set Parameter #4 to value #1

2. Double click the Tamper Switch.

3. Result:

Blinks once - success

Blinks 5x times - failure

This device is capable of receiving a new firmware 'over the air'. The update function needs to be supported by the central controller.

Once the controller starts the update process, perform the following action to confirm the firmware update:

1. Wake Up the device by removing the cover.

2. The hit the tamper switch once.

Send a wake up notification.

In order to send your sensors new configuration commands from your Z-Wave controller or gateway, it will need to be woken up.

1. Wake Up the device by removing the cover.

2. The hit the tamper switch once.

Note: Door / Window Sensor 7 remains awake until the housing is closed again.

Remove your Door / Window Sensor 7 from Z-Wave network.

https://aeotec.freshdesk.com/support/solutions/articles/6000218764-door-windows-sensor-7-user-guide

Door / Window 7 user guide : Aeotec Group

6/9