Aeotec MultiSensor Kullanıcı Kılavuzu - Sayfa 9
Aksesuarlar Aeotec MultiSensor için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aeotec MultiSensor 10 sayfaları. Z-wave 4-in-1 sensor:
motion, temperature, humidity, and light sensor
Ayrıca Aeotec MultiSensor için: Kurulum Talimatları (3 sayfalar)
Sayfayı Yazdır
16-08-13
Troubleshooting
If the MultiSensor was successfully removed from the Z-Wave
network, pressing the Z-Wave button will cause the LED to
blink. If the MultiSensor was not successfully removed from
the Z-Wave network the LED will stay solid for a few
seconds.
Monitoring Motion.
The MultiSensor can send Basic Set Command to
association group 1, which is setup via the Association
Command Class, when the MultiSensor detects motion to
control the associated devices to "OPEN" state. After 4
minutes by default, if the Motion Sensor is not triggered
again, the MultiSensor will send Basic Set Command to
these devices to control them to "CLOSE" state, but if the
Motion Sensor is triggered again in 4 minutes, the
MultiSensor will reset the timing, and start to timing again.
The 4 minutes delay time can be changed through the usage
of Z-Wave command built into Z-Wave certified
controllers/gateways. The specific Z-Wave command
supporting this function is Configuration Command Class.
Please consult the operation manual for these controllers /
gateways for specific instructions on setting the Multisensor.
aeotec.com/z-wave-sensor/47-multisensor-manual.html
MultiSensor Manual - Aeotec
9/10