Ariston 60 cm Servis Kılavuzu - Sayfa 30

Buzdolabı Ariston 60 cm için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Ariston 60 cm 47 sayfaları.

Sayfayı Yazdır

FAULT

CAUSE

FRIDGE Evaporator NTC probe

F23

open / short-circuit

FREEZER Air NTC probe open /

F24

short-circuit

FREEZER Evaporator NTC probe

F25

open / short-circuit

CCZ Air NTC probe open / short-

F26

circuit

F28

Display PCB does not work

F40

"ON/OFF " button does not work

F41

"I Care" button does not work

F42

"Holiday" button does not work

F43

"ICE PARTY" button

"Ever Fresh" button

F44

F45

"Super Freeze" button

F46

"Super Cool" button

F47

"Alarm" button

F49

FRIDGE "+" button

F50

FRIDGE "-" button

CCZ button

F51

F52

FREEZER "+" button

F53

FREEZER "-" button

Service Manual

NEW ARISTON 60 cm PLATFORM

CORRECTIVE ACTIONS

- Check efﬁ ciency of contacts on connector J11 on the PCB;

- Check NTC probe, ensuring that the impedance value read on pins 1 and 2 of

wiring connector J11 is compatible with the values in the temperature-imped-

ance correlation table (also heat the probe by holding it with your hand where

possible and checking the change in the impedance value);

- Renew main PCB.

- Check efﬁ ciency of contacts on connector J11 on the PCB;

- Check NTC probe, ensuring that the impedance value read on pins 5 and 6 of

wiring connector J11 is compatible with the values in the temperature-imped-

ance correlation table (also heat the probe by holding it with your hand where

possible and checking the change in the impedance value);

- Renew main PCB.

- Check efﬁ ciency of contacts on connector J11 on the PCB;

- Check NTC probe, ensuring that the impedance value read on pins 1 and 2 of

wiring connector J11 is compatible with the values in the temperature-imped-

ance correlation table (also heat the probe by holding it with your hand where

possible and checking the change in the impedance value);

- Renew main PCB.

- Check efﬁ ciency of contacts on connector J12 on the PCB;

- Check NTC probe, ensuring that the impedance value read on pins 3 and 4 of

wiring connector J11 is compatible with the values in the temperature-imped-

ance correlation table (also heat the probe by holding it with your hand where

possible and checking the change in the impedance value);

- Renew main PCB.

- Renew Touch display PCB

Edition

2006.06.15

Language

English