Whirlpool AWM 8000/PRO Kurulum Kılavuzu - Sayfa 5

Yıkayıcı Whirlpool AWM 8000/PRO için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Whirlpool AWM 8000/PRO 6 sayfaları.
Ayrıca Whirlpool AWM 8000/PRO için: Kurulum Kılavuzu (40 sayfalar)

Sayfayı Yazdır

CONNECT THE WATER INLET HOSE

7. - If the water inlet hose is not already installed,

it must be screwed to the appliance.

If your washing machine has one inlet valve on

the back: connect it to cold fill only.

8. - If your washing machine has two inlet valves

on the back, you must connect both valves

to the water supply:

• either connect red inlet valve to hot fill tap and

blue inlet valve to cold fill tap.

• or connect both inlet valves to cold water tap by

using a Y-adapter.

Make sure all connections are tightly fixed.

Screw the inlet hose by hand to the tap and to the

inlet valve and tighten the nut. Do not use any

tools for fixing the inlet hose.

Attention

• No kinks in the hose!

• The appliance must not be connected to the mixing tap of an un-pressurized water

heater.

• Check water-tightness of connections by turning the tap completely on.

• If the hose is too short, replace it with a suitable length of pressure resistant hose

(1000 kPa min, EN 50084 approved type).

• Check the inlet hose regularly for brittleness and cracks and replace if necessary. It is

generally recommended to renew the inlet hose every 3 years.

• The washing machine can be connected without a non-return valve.

- For models with Water Stop hose:

If the flexible hose is too short, replace it with a longer Water Stop

hose available through our After-Sales Service or from your dealer.

The replacement must be carried out by an expert. While unscrewing

the water stop hose, the release lever must be pushed down.

Cold fill

Hot fill

Blue inlet valve

Red inlet valve

Y-adapter

release lever

Cold fill