Whirlpool 3395339 Kurulum Talimatları Kılavuzu - Sayfa 8

Kurutucu Whirlpool 3395339 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool 3395339 12 sayfaları. Coin-operated stacked dryers

Sayfayı Yazdır
ratchet
tooth
ratchet
tooth
timyg
cam a
line up notch
to clear
\
drive lug
ratchet
tooth.
4. Insert a narrow,
flat-blade
screwdriver
under the timing cam
near the clock shaft. Gently
lift cam
straight up and off shaft making
sure
that the "V-shaped
notch clears the
ratchet
tooth.
5. Place new cam (hub side down)
over clock shaft
Line up flat side of
shaft with flat side of cam hole.
Check
that drive lug is in place.
6.
Turn cam until "V-shaped
notch
lines up with ratchet
tooth.
7. Press cam down in place
on motor
shaft. Make sure that "V"-shaped
notch clears the ratchet
tooth,
8.
Reattach
the timer bracket
assembly;
tighten
the screws,
9. Repeat
steps for other timer
10.
Close and lock the control
panel.
Now start...
With dryers in laundry
area.
1
n
Check
that each
leg is
approximately
1 inch from base.
2.
Wipe the interior of the drums
thoroughly
with a damp
cloth
3.
Install coin vaults and locks (not
supplied)
into meter case openings.
4.
Install control
panel
lock and key (not
supplied).
Electrical
Shock Hazard
Control
panel
must be closed
and
locked
at all times.
Failure to do so could result in
serious injury or death.
If you wish to change
the 45minute
dryer timing cams to either 30- or 60-
minute timing cams, see "To change
to a 30- or 60-minute
timing cam,"
Pages 7 and 8. Complete
all of the
steps given in that section
before
going to Step 6.
Electrical
Shock Hazard
Disconnect
electrical
power at the
service
panel
(fuse box or circuit
breaker
box).
Failure to do so could
result in
serious injury or death.
Open control
panel
and rest it on the
bottom
edge
of the opening.
Attach
slide extension
(with flange
pointing
down)
to one of the coin-slide
mechanisms,
Insert the coin-slide
mechanism
through
the opening
to
the left of the control
panel.
7.
Secure coin-slide
mechanism
from
inside the control
panel
using the
3/l 6" bolt and washer supplied.
Install
coin box.
8
n
Repeat
Steps 6 and 7 for the other
coin-slide
mechanism.
Close control
panel.
9..
Insert top of wire guard
into holes on
each side of the coin-slide
mechanism.
Insert screws through
hooked
ends of guard
and tighten.
Repeat
for other wire guard.
Page 8