Whirlpool 3395339 Kurulum Talimatları Kılavuzu - Sayfa 6

Kurutucu Whirlpool 3395339 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Whirlpool 3395339 12 sayfaları. Coin-operated stacked dryers

Sayfayı Yazdır
Product
Damage
Keep air openings
free of dry-
cleaning
fluid fumes. Fumes
create
acids which, when drawn
through
the dryer heating
units,
can damage
dryers and loads
being dried.
L
A clean-out
cover should be located
on the main exhaust
duct for
periodically
cleaning
the exhaust
system.
An exhaust
hood should cap the
outside
end of the main duct to
prevent
exhausted
air from returning
to the dryers. If an exhaust
hood
cannot
be used, the outside end of
the main duct should have a sweep
elbow
directed
downward.
If the
main duct travels vertically
through
the roof rather than through
the wall,
install 180" sweep
elbow
on the end
of duct at least 2 feet above
the
highest part of the building.
The
opening
wall or roof shall have a
diameter
l/2 inch larger than the
exhaust
duct diameter.
The exhaust
duct should be centered
in the
opening.
exhaust
hood or
Exhaust duct
connection
Electrical
Shock Hazard
Disconnect
both power supply
cords before
making
these
changes.
Failure to do so may result in
electrical
shock or personal
injury.
Determine
which direction
you need
to attach
the exhaust
ducts to the
dryers. Both dryers can be exhausted
straight
out the back or from the right
or left side. The lower dryer can also
be exhausted
through
the bottom.
Next, determine
the length of exhaust
duct you will need to connect
the
dryers to exhaust
hoods or the main
exhaust.
To connect
exhaust
duct
straight
out the back-
l-l
RI+
wall
2
ft.
min.
highest point of
180
sweep
main collector
Do Not install screening
cap over end
of duct.
Attach
exhaust
duct to each
dryer
duct. Then connect
exhaust
ducts to
exhaust
hoods or main exhaust.
Use
duct tape to seal all joints.
This dryer may be converted
to be
exhausted
out the right or left side or
through
the bottom.
To convert
the
dryer, one of the following
kits MUST
be used:
Exhaust Kit No. 279818 (White)
Exhaust Kit No. 279819 (Almond)
Follow the instructions
in the Kit to
avoid
operational
and personal
hazard.
Page 6