Whirlpool AZA9791 Kullanım Kılavuzu - Sayfa 11

Kurutucu Whirlpool AZA9791 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Whirlpool AZA9791 18 sayfaları.

CLEANING THE BOTTOM FILTER

A. Open the bottom filter flap. Lift up the handle of the filter and

pull the bottom filter out.

B. Open the filter by lifting on the latch of the filter frame.

C. Take out the foam from the inside of the filter.

D. Remove the lint on the surface of the foam by hand.

Afterwards, clean the foam under running water to remove

any remaining lint from the foam.

E. Remove the lint from both filter parts by hand. If a white

substance remains on the filter mesh that cannot be removed

by hand, clean the filter parts under running water. If

necessary, use a soft brush.

F. Put the foam back into the filter frame. The foam could also

put inside the filter when it is wet, there is no effect to the

drying result.

G. Install the filter frame into the housing by inserting the tabs of

the frame into the slots on the filter housing and clicking the

latch into place. Please take care that the foam is not pinched

between the filter parts.

H. Clean the filter housing and the mesh inside by hand, with a

damp cloth, or very carefully with a vacuum cleaner.

I. Install the filter again in the dryer, with the handle in

horizontal position. When the filter is fully inserted, move the

handle downwards to lock the filter in place. Ensure that the

handle is fully engaged on both sides behind the hooks of the

housing area.

J. Fix the bottom filter flap again.

IMPORTANT:

•

Clean the bottom filter after every 5th drying cycle

approximately.

•

For performance tests according to EN 61121 by test

institutes, the bottom filter must be cleaned after each drying

cycle.

•

Make sure that the filter meshes and foam are dry before

starting a new drying cycle.

•

The filter foam must not be washed together with laundry in a

washing machine.