Whirlpool BYCD3722W0 Kullanım ve Bakım Kılavuzu - Sayfa 12
Kurutucu Whirlpool BYCD3722W0 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Whirlpool BYCD3722W0 19 sayfaları. Electric and gas dryers
Sayfayı Yazdır
CARING
HJRYOURDKVER
Proper care of your dryer can extend its life and help your dryer operate efficiently.
CEANIN~ ME urn sam
Every load cleaning
The lint screen is located under a lid on top of the
dryer.
Clean it before each load.
A screen blocked
by lint can increase drying time.
To clean:
1.
Open the lid and pull the lint screen towards you.
2. Roll lint off the screen with your fingers. Do not
I
rinse or wash screen to
remove lint. Wet lint is
hard to remove.
3. Push the lint screen firmly back into place and
close the lid.
IMPORTANT:
0 Do not run the dryer with the lint screen loose,
damaged, blocked, or missing. Doing so can
cause overheating
and damage to both the dryer
and fabrics.
0 Some towels made of synthetic fibers and natural
fibers (polyester and cotton blends) may shed
more lint than other towels, causing your dryer's
lint screen to fill up faster. Be sure to remove
lint from the lint screen before and after drying
new towels.
0 If lint falls into chute, double-check
exhaust hood
and clean out lint if necessary.
AS needed cleaning
Laundry detergents and fabric softeners can cause
a residue buildup on the lint screen. This buildup
can cause longer drying times for your clothes, or
cause the dryer to stop before your load is com-
pletely dry. You may be able to see this buildup,
or the lint may be falling off the screen because it
is clogged.
Clean the lint screen with a nylon brush every six
months or more frequently
if it becomes clogged
due to a residue buildup.
Use the following method:
1.
Wet both sides of lint screen with hot water.
2. Wet a nylon brush with hot water and liquid
2. Wet a nylon brush with hot water and liquid
detergent; scrub lint
detergent; scrub lint
screen with the brush to
screen with the brush to
remove residue buildup.
remove residue buildup.
3. Rinse screen with hot water.
4. Thoroughly
dry lint screen with a clean towel;
replace in dryer.
12