ABB CoriolisMaster FCH400 Series Yapılandırma Kılavuzu - Sayfa 6

Kontrol Ünitesi ABB CoriolisMaster FCH400 Series için çevrimiçi göz atın veya pdf Yapılandırma Kılavuzu indirin. ABB CoriolisMaster FCH400 Series 11 sayfaları. Hspc module

Sayfayı Yazdır
5.
Verify correct polarity in all terminal connector wiring.
6.
Reinsert terminal connectors on module.
7.
Wire the (non-energized) power supply terminals, ensuring correct polarity. Refer to the power
supply documentation for details.
4

Wire the CoriolisMaster digital output

This procedure shows how to wire one of the CoriolisMaster digital outputs to the HSPC module. This
procedure wires Digital Output 1 (pins 41, 42). Digital Output 41/42 supports many configuration
options. It is assumed that this output has been configured as a frequency output.
Prerequisites:
–
The CoriolisMaster is not powered.
–
Review and meet wiring requirements (wire gauge, length, use wire-end ferrules to prepare wire
for insertion, etc.) See
To wire Digital Output 1 (41/42):
1.
Locate the Digital Outputs on the CoriolisMaster terminal connector.
2.
Insert the Signal wire from HSPC J1-1 in pin 41.
3.
Insert the GND wire from HSPC J1-2 in pin 42.
connection.
Figure 4-1: HSPC Module wired to CoriolisMaster and External power supply
5

Power the HSPC module and CoriolisMaster

This procedure applies power to both the HSPC module and the CoriolisMaster.
Prerequisites:
–
All wiring on the HSPC and the CoriolisMaster is complete.
6 | HS PC CO N FI G U RATI ON G UI D E | 21 08 7 44M N A A
Additional
information.
Figure 4-1
shows the HSPC to Coriolis