Xerox 220 Hızlı Kurulum Kılavuzu

Yazıcı Xerox 220 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Xerox 220 8 sayfaları. Scanning services
Ayrıca Xerox 220 için: Hızlı Kurulum (1 sayfalar), Taramaya Genel Bakış (2 sayfalar), Başlarken (48 sayfalar)

Sayfayı Yazdır
Xerox 220 Hızlı Kurulum Kılavuzu
DC220/230/332/340ST Windows NT
Installation Requirements:
•
Be sure that the DC220/230/332/340ST is
correctly set up and configured for TCP/IP.
•
The DC220/230/332/340ST Scan To File
option kit must be installed before
performing this procedure.
•
For an NT server, ensure that Microsoft
®
Internet Information Services
installed on the server.
•
To install the DC220/230/332/340ST into a
DHCP environment, exclude the addresses
assigned to the DC220/230/332/340ST at
the DHCP server.
•
For NT workstations, ensure that Microsoft
®
Peer Web Services
is installed on the
clients.
Note: Installing Microsoft IIS or Peer Web
Services requires that the server or workstation
be rebooted.
Before Installation:
Please review the DC220/230/332/340ST
Scanning Overview card before proceeding.
For assistance, contact your local Xerox Customer Support Center
602E60380
7KH 'RFXPHQW &RPSDQ\
At the Repository Server:
1.
Create a Repository Directory at the NT
server or NT workstation.
a)
Record the TCP/IP address of the
Repository Server for later use:
_________________________________
2.
Assign users and rights to the Repository
(IIS) is
Directory.
3.
Create a user account and assign a
password for the DC220/230/332/340ST
to use to log in to the Repository Server.
For NTFS drivers, Change permission to
the Repository Directory is required for the
DC220/230/332/340ST account. For the
NT4.0 server account, the Log on Locally
permission is required.
a)
Record the name of the user account
and the password for later use:
_________________________________
_________________________________
4.
Ensure that FTP services are running at
the Repository Server by running
Microsoft Internet Service Manager
;(52;
®
4.0 (TCP/IP) Scan to File Quick Install
®
:
Page 1 of 2
a)
Select the FTP service. From the
toolbar, select Properties > Service
Properties > Directory tab.
b)
Select Add, then browse for the
Repository Directory and make this
the Home Directory for the FTP
service (Example: c/scandir).
c)
Select both the Read and Write check
boxes under Access.
d)
Select the OK button.
5.
Test the FTP connection to the Repository
Server by logging in to the server from
another workstation, using the User Name
and Password created earlier.
6.
Record the path the user account will
need to get to the Repository Directory,
i.e. [/], if you made this your Home
Directory.
_________________________________
At the DC220/230/332/340ST Control
Panel:
1.
Enter System Administrator Setups:
a)
Press the [Access] button on the
Control Panel.
Over