Caleg WOWMAKER 9003305 Hızlı Başlangıç Kılavuzu - Sayfa 2

Endüstriyel Ekipmanlar Caleg WOWMAKER 9003305 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Caleg WOWMAKER 9003305 2 sayfaları.

WOWMAKER – Attaching the eye bolts and lifting it out of the Studiolift.

STEP 1: Turn the WOWMAKER off and disconnect all cables connected to the Studioframe (as delivered: 2x

Neutrik plugs and 1x connection to S-Box).

STEP 2: Screw the eye bolts flat on the frame into the block using a hex key.

STEP 3: Connect the bolts to a crane or other hoist device so that the Studioframe is secure even without the

Lifter.

STEP 4: Loosen the locking screws (2x). Caution, spacer washer is no longer fixed.

STEP 5: Loosen the screws of the holding knobs (4x) one turn with a 7 mm hex key.

STEP 6: Lift the Studioframe vertically out of the Lifter with the crane.

Block with screw thread

under the frame

Holding knobs

ATTENTION: Never stand under a suspended load! Stay out of the extended danger zone where risk

of the suspended load falling may occur!

ATTENTION: The eye bolt's suspension point is not suitable for swiveling under load.

ATTENTION: Do not use the eye bolt to lift persons!

ATTENTION: Observe the instructions for use, operation and maintenance provided by the

manufacturer of the eye bolts. Non-compliance may cause personal injury and damage to property.

Eye bolt

screwed in flat

Locking screw

(middle)

Holding knob

(bottom)