Xerox Phaser 860 Ağ Kurulumu Kılavuzu - Sayfa 25

Yazıcı Aksesuarları Xerox Phaser 860 için çevrimiçi göz atın veya pdf Ağ Kurulumu Kılavuzu indirin. Xerox Phaser 860 42 sayfaları. Color printer
Ayrıca Xerox Phaser 860 için: Tepsi Modülü Kurulum Kılavuzu (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Kurulum Kılavuzu (1 sayfalar), Hızlı Yayın Kılavuzu (1 sayfalar), Tamamlayıcı Kılavuz (1 sayfalar), Tamamlayıcı Kılavuz (11 sayfalar), Broşür ve Teknik Özellikler (4 sayfalar), Menü Haritası (1 sayfalar), Kurulum ve Hızlı Referans Kılavuzu (36 sayfalar), Kurulum Kılavuzu (1 sayfalar), Servis Kılavuzu (11 sayfalar)

If the printer is not in the Chooser, check that the Configuration Page shows a printer

name, a node number, and a zone.

If there is no node number, verify that the printer is properly cabled to the network.

Test the cable segment by plugging in a new cable segment or using the cable segment

of a printer that is in the Chooser.

If your network uses zones, and there is no zone name on the Configuration Page, or if

the Configuration Page shows the wrong zone, see page 21.

Note

If the printer cannot create a zone, it must already exist.

If the Configuration Page shows the correct printer name, node number, and zone, and the

printer is still not visible in the Chooser, check the following items:

If there is a Novell NetWare server on the network, verify that the NetWare server has

been configured for AppleTalk Phase 2 routing and addressing.

If there is a Windows NT server on the network, verify that the printer has not been

captured by a Windows NT machine.

If the printer continually reboots when connected to the network, it is possible that a

router is broadcasting a zone of *, which is an invalid zone.

If using QuickDraw GX, the GX drivers must be installed. If you don't use QuickDraw

GX, disable the QuickDraw GX, QuickDraw Helper, and ColorSync extensions.

Networking Setup Guide

EtherTalk Configuration