Yamaha AW4416 Kılavuz Eki - Sayfa 3

Müzik Enstrümanı Yamaha AW4416 için çevrimiçi göz atın veya pdf Kılavuz Eki indirin. Yamaha AW4416 48 sayfaları. Installing an internal hard disk
Ayrıca Yamaha AW4416 için: Ek Kılavuz (1 sayfalar), Öğretici (34 sayfalar), Ek Kılavuz (20 sayfalar), Manuel (3 sayfalar)

Sayfayı Yazdır
Yamaha AW4416 Kılavuz Eki

Operation

Extensions to the Quick Rec function

The Quick Rec screen now has two pages: Quick Rec
1 and Quick Rec 2. Operations corresponding to what
was the previous Quick Rec page are performed in
the Quick Rec 1 page, and the newly added Quick
Rec 2 page allows the various input signals/input
channels to be freely patched to the tracks of the
recorder.
By using the appropriate page (Quick Rec 1 or Quick
Rec 2), you can make patching settings more effi-
ciently.
Quickly assign input sources to
tracks
By using the Quick Rec 2 page, you can quickly
assign any input source/input channel to a recorder
track. Here's how.
1
In the WORK NAVIGATE section, press the
[Quick Rec] key
[F2] (Quick Rec 2) key.
The Quick Rec 2 page will appear. This page dis-
plays the following information.
1
A
MIX.CH (Input channel)
This area shows the type of input signal that is
assigned to each input channel 1–16. The
symbols (jacks) displayed at the right of this area
indicate the direct output of each input channel.
B
REC.TR (Recorder track)
This area shows tracks 1–16 (Tr1–Tr16). The
symbols (jacks) displayed at the left of this area
indicate the input to each track.
2
2
3
Tip!

Version 2.0 Manual Supplement

To change the input source that is assigned
to an input channel, move the cursor to
the number box of the corresponding
channel, and turn the [DATA/JOG] dial.
The following types of input source can be
assigned to an input channel.
• AD 1–AD 8 .............Input signals from INPUT
1–8 jacks
• SL1-1–SL1-8 ............Inputs 1–8 from an I/O
card (slot 1)
• SL2-1–SL2-8 ............Inputs 1–8 from an I/O
card (slot 2)
• DIN L/DIN R ..........L or R channels from the
DIGITAL STEREO IN jack
• SMP 1–SMP 8..........Sampling pads 1–8
• MET ........................Internal metronome
In the MIX.CH area, move the cursor to the
patch-source jack, and press the [ENTER]
key.
The corresponding input channel will be high-
lighted, and selected as the patch-source.
If you move the cursor to a highlighted input channel
and press the [ENTER] key once again, the selection
will be cancelled.
3