Yamaha AW4416 Kılavuz Eki - Sayfa 4
Müzik Enstrümanı Yamaha AW4416 için çevrimiçi göz atın veya pdf Kılavuz Eki indirin. Yamaha AW4416 48 sayfaları. Installing an internal hard disk
Ayrıca Yamaha AW4416 için: Ek Kılavuz (1 sayfalar), Öğretici (34 sayfalar), Ek Kılavuz (20 sayfalar), Manuel (3 sayfalar)
Sayfayı Yazdır
AW4416 Version 2.0 Manual Supplement
4
In the REC.TR area, move the cursor to the
jack for the desired patch-destination track,
and press the [ENTER] key.
The patch-source and patch-destination in the
screen will be connected by a patch cable.
Tip!
• You may perform steps 3 and 4 in reverse order.
• It is also possible to connect the direct output of the
same channel to multiple tracks. However, it is not
possible to connect multiple direct outputs to a sin-
gle track.
5
Make connections for other input channels
in the same way.
Tip!
• To cancel a specific patch cable, move the cursor to
the CLEAR button located at the right of the corre-
sponding recorder input, and press the [ENTER] key.
• To cancel all patch cables, move the cursor to the
ALL CLEAR button located at the upper right of the
display, and press the [ENTER] key.
4
6
When you are finished making patch cable
connections, move the cursor to the EXE-
CUTE button located in the lower right of
the display, and press the [ENTER] key.
The following popup window will appear.
7
To execute the Quick Rec function, move
the cursor to the OK button and press the
[ENTER] key.
To cancel the operation, move the cursor to the
CANCEL button and press the [ENTER] key.
When you execute Quick Rec, the internal set-
tings of the AW4416 will change as follows.
• The input patch and recorder input settings will
be set according to the settings of the Quick
Rec 2 page.
• Assignments to the stereo bus will be forcibly
cancelled for any input channel to which a
patch cable is connected.
• Channel library number 01 will be recalled for
the monitor channel of any track to which a
patch cable is connected, restoring it to the
default condition.
Tip!
If desired, each input channel to which a patch cable
is connected can be initialized when you execute
Quick Rec. To do this, move the cursor to the FLAT/
CURRENT button located in the upper left of the dis-
play, and press the [ENTER] key to make the button
read "FLAT."
[Reference pages]
Details on the Quick Rec 2 page
Version 2.0 Manual Supplement
P.23