Yamaha XMV4140-D Kullanıcı El Kitabı - Sayfa 12
Amplifikatör Yamaha XMV4140-D için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha XMV4140-D 42 sayfaları. Power amplifier
Ayrıca Yamaha XMV4140-D için: Kullanıcı El Kitabı (43 sayfalar)
Sayfayı Yazdır
Controls and Functions
Rear Panel
XMV4280/XMV4140
!9
@0
@3
XMV4280-D/XMV4140-D
@1
@3
!9 Network connector (XMV4280/XMV4140 only)
This is a 100BASE-TX Ethernet connector that allows the
unit to be connected to a computer via an Ethernet cable.
NOTE
• Use a CAT5e or better STP (Shielded Twisted Pair) cable
for the network connection to prevent electromagnetic
interference.
• When using MTX Editor to control the XMV, you must con-
nect the MTX.
12
XMV4280/XMV4140/XMV4280-D/XMV4140-D Owner's Manual
@2
ON
1
2
3
4
5
6
7
8
@4
@2
ON
1
2
3
4
5
6
7
8
@4
@5
@7
@8
@6
@5
@7
@8
@6
@0 [YDIF] connectors (XMV4280/XMV4140 only)
These are RJ-45 connectors that allow the unit to be con-
nected via an Ethernet cable to another YDIF-equipped
device so that audio signals and word clock signals can be
transmitted and received. Using a ring connection (YDIF
connection), you can connect to other devices equipped with
a [YDIF] connector. For details on settings for receiving
audio signals via the [YDIF] connector, refer to "Front Panel
Operations" (page 23).
Cables used for this connection should be 30 meters or less
between devices. Up to eight devices can be connected in a
network with YDIF connection.
For information on connections that use [YDIF] connectors,
refer to the "MTX Setup Manual."
NOTE
To prevent electromagnetic interference, make connections
to the [YDIF] connector using a CAT5e or better STP
(Shielded Twisted Pair) cable in which all pins are con-
nected with a straight connection.
@9
@9