Yamaha XMV4140-D Kullanıcı El Kitabı - Sayfa 13

Amplifikatör Yamaha XMV4140-D için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Yamaha XMV4140-D 42 sayfaları. Power amplifier
Ayrıca Yamaha XMV4140-D için: Kullanıcı El Kitabı (43 sayfalar)

Sayfayı Yazdır

@1 Dante [PRIMARY]/[SECONDARY] connectors

(XMV4280-D/XMV4140-D only)

These are RJ-45 connectors that allow the unit to be con-

nected to another Dante device such as the MTX5-D via an

Ethernet cable. The Dante [PRIMARY] connector can also

be used to connect to a computer via an Ethernet cable. To

connect, refer to the "MTX Editor User's Manual."

NOTE

• Use a CAT5e or better STP (Shielded Twisted Pair) cable

for the connection to the Dante [PRIMARY]/[SECOND-

ARY] connectors to prevent electromagnetic interference.

Make sure that the metal parts of the plugs are electrically

connected to the STP cable shield by conductive tape or

comparable means.

• Connect only Dante-compatible devices or GbE-compati-

ble devices (including a computer).

• Since Dante-compatible equipment made by Yamaha

such as the XMV4280-D/XMV4140-D contains a built'-in

network switch, the number of hops will be two or more.

For this reason, the 0.15 msec Latency setting in Dante

Controller will be grayed-out and unavailable.

@2 [UNIT ID] rotary switch

If multiple devices such as XMVs or MTXs are connected

on the same network, this rotary switch enables you to spec-

ify the UNIT ID that identifies each unit individually.

XMV4280/XMV4140

With the combination of the device setup DIP switches

1–3 @3 for upper digits and the rotary switch for lower dig-

its, the UNIT ID can be specified in a maximum of 127

values, from "01" to "7F."

XMV4280-D/XMV4140-D

With the rotary switch (HIGH) used for upper digits and

the rotary switch (LOW) for lower digits, the UNIT ID can

be specified in a maximum of 254 values, from "01" to

"FE."

NOTE

• Do not use "00" or "FF" as the UNIT ID.

• After you set the [UNIT ID] rotary switch, turn the power to

the unit off and then on.

@3 Device setup DIP switch

This DIP switch is used to make settings for the XMV. Refer

to the following for details on the settings.

NOTE

To change the switch settings, turn off the power to the unit.

If you change the settings while the power is on, the change

will not be effective until you turn the unit off and then on.

Refer to the following for details.

Switch

Indicates the switch is in the upward posi-

tion.

Indicates the switch is in the downward posi-

tion.

XMV4280/XMV4140

XMV4280-D/XMV4140-D

NOTE

Switch 1 and 2 are not used for the XMV4280-D/XMV4140-

D. Use the swiches in the factory set state (upward).

XMV4280/XMV4140/XMV4280-D/XMV4140-D Owner's Manual

Controls and Functions

Status