Directechs DB3 Kurulum Kılavuzu - Sayfa 5

Otomobil Elektroniği Directechs DB3 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Directechs DB3 20 sayfaları. 2011 subaru outback - 403.subaru2 1.25
Ayrıca Directechs DB3 için: Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (10 sayfalar), Kullanım Kılavuzu (17 sayfalar)

Sayfayı Yazdır

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

compatible

Vehicle Takeover

Firmware notes

OEM Remote Starter: Before programming your module, you must first check if your vehicle is equipped with an OEM remote

starter and disable it. If the vehicle is equipped with an OEM remote starter, whether Active or Inactive, it MUST be temporarily

disabled or permanently disconnected depending on the vehicle. Please refer to the "OEM remote starter information" section of the

guide for additional details. Also, to remote start the engine, all doors must be closed.

Note: In some cases, the module will program to the vehicle even if equipped with an OEM starter, but will prevent the aftermarket

remote start from functioning properly.

Remote Start: All doors must be closed and locked to remote start the vehicle.

Motorized Hatch: If available, the Motorized Hatch feature needs to be enabled using the configuration tool found on the module

flashing page on www.directechs.com.

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.

Refer to the "Vehicle connections" following the installation diagram.

Footnotes

[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin, or if

not supported in data.

[2] Tach wire: Optional connection required on some remote starters, which do not support a tach signal in D2D.

[3] Pit Stop/Idle mode: This connection is only required for Pit Stop/Idle mode in manual transmission vehicles or Ready mode for

vehicles with hybrid engines.

[4] SLP: See "Locating Steering Lock Connector in Vehicle" in Vehicle wiring reference chart.

403.TL8 2.32 2015 Lexus NX 200t (Smart Key)

The engine will shut off when a door is opened.

Keys required for

Keys required

programming

for operation